3.4 Connect Satellite Antenna to Satellite Interface
Locate the primary coax cable from roof top antenna. Connect it to “Sat Antenna In” on the Satellite Interface. See Figure 3.6.
Figure 3.6
|
| DC OUT | COMM. OUT 1 |
|
| FACTORY | SAT. | SAT. | ||
|
| TO SAT |
| TO SAT. | HD | HD | USE | RECEIVER | ANTENNA | |
DC IN |
| ANTENNA |
| ANTENNA | CTRL 2 | CTRL 1 | ONLY | OUT | IN | |
|
| BLK/RED |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
The primary coax ca- ble is connected to the elec- tronics board inside of the dome. In most antennas, the secondary coax must be connected to the second- ary coax port inside of the dome. See the manual for more information.
3.5 Connect Satellite Interface to Primary HD Receiver
Depending on your satellite service provider, you must connect the Satellite Interface to your primary HD receiver in 1 of 2 ways. The DirecTV installation begins on the next page. See page 11 for Dish Network and Bell ExpressVU installation.