You must now choose if you subscribe to DISH 500 or DISH 1000 programming. Call Dish Network customer service if you are unsure of your programming option. If you sub- scribe to all High Definition programming, you should choose the DISH 1000 option.
Press [SELECT] to select your Dish Network Programming Type.
Satellite Interface
POWER |
|
| DISH 1000* | SELECT |
| ENTER |
|
| DISH 500 |
| |||
|
|
|
|
|
|
Press [ENTER] to confirm. Select Yes and press [ENTER] to save the setting.
A confirmation message will appear. The satellite antenna will reset and begin its search routine for satellite 119. Your satellite antenna is now set for Dish Network programming. Each time you power on the Satellite Interface, the satellite antenna will locate Dish Net- work programming.
Configure Dish Network Receiver
In order to use the satellite antenna in automatic mode, the Dish Network Receiver must be configured with the proper switch installed.
The Dish Network switch tells the receiver which satellite to look at, depending which channel the receiver is tuned to.
If you use your receiver in your RV only, you should only have to run the “Check Switch” test during the initial installation.
If you move your Receiver between your RV and your home, you must run the “Check Switch” test each time you move your receiver. For example, if your receiver is in your home and you move it to your RV, you must run the check switch test once your RV’s satellite system is on signal. If you move your receiver from your RV to your home, you should run the check switch after you have connected your receiver to your home antenna. Refer to your receiver manual for more information.
Install the Satellite Switch
For most Dish Network receivers, the following commands will help you navigate to the correct menu locations. If you need help reaching the following menus, refer to your receiver’s manual.
Power on your satellite receiver and press [POWER] on the Satellite Interface.
The antenna will begin its search routine and lock on to and come to rest on satellite 119°W after some satellite verification.
If you have an
The Dish Network switch is a receiver setting, not a physical part.
If you install a sec- ond receiver, you should connect the secondary receiver to the primary coax and run the switch test. Af- ter test is complete, connect the receiver to secondary coax at receiver’s perma- nent location.
18