Winegard WB-2000 Appendix B. Recommended Receivers, Appendix C. Normal Operating Messages

Page 38

Appendix B. Recommended Receivers

Winegard recommends the following receivers for use with your Winegard Automatic Satellite System. Winegard does not recommend the use of receivers with hard drives for mobile use. All information below is accurate as of March, 2007. Receivers and compatibility is subject to change without notice.

Service Provider

Standard Receiver

HD Receiver

DirecTV

D10, D11

H10, H20

Dish Network

311, 301

VIP 211

Bell ExpressVU

3100

4100

Appendix C. Normal Operating Messages

The Winegard Satellite Interface LCD screen keeps the user informed as to what the dish is doing through simple messages. Below is a short table of messages that are displayed dur- ing normal operation.

The LCD screen will also give feedback when an error has occurred either in the antenna or in communication with the antenna.

Message

Dish Status

To Clear

SLEEP

Stationary Units: Target satellite has been

Press [ENTER] to clear manually and

MODE

acquired

return to status screen, or wait 1 minute to

 

In-Motion Units: Target satellite has been

automatically clear

 

acquired & vehicle exited Tracking Mode

 

 

to sleep Mode

 

HOMING

Antenna is searching for the elevation limit

Will clear when antenna sets elevation

ELEVATION

switch

home position

HOMING

Antenna is searching for the azimuth limit

Will clear when antenna sets azimuth home

AZIMUTH

switch

position

SEARCHING

Antenna is searching for the target satellite

Will clear when target satellite has been

 

 

identified

connecting to

Interface is powering up & interface &

Will clear within 30 seconds of power up

antenna

antenna are establishling communications

under normal operation

36

Image 38
Contents Winegard Page Congratulations Disclaimer TrademarksTable of Contents Solutions to Common Operating Issues Product Line Model # Service Provider Available SatellitesSystem Overview Parts Provided With HD System 1. HD Satellite Interface BoxSatellite Interface Components Hdtv Satellite Interface Power ButtonAccessing the Main Menu Select a Location to Install the Satellite Interface Installation SafetyTools and Material Required for Installation Red Wire Plug Power Cable into Satellite Interface Black WireConnect Satellite Antenna to Satellite Interface Satellite Interface Connect the Satellite Interface to 110VAC Power Satellite InterfaceInstall Software Update with Clone Box if necessary See FigureConnect Data Cable to Electronics Board and Replace Dome Press Enter to confirm Sat Provider DirecTV OperationDirecTV Overview Choosing the Satellite Pair Important DirecTV Program Guide and Channel NoteExample of DirecTV Satellite Switching Dish Network Operation Dish Network OverviewConfigure Dish Network Receiver Install the Satellite SwitchDish SW42 Dish SW64Vary Watching Dish Network programmingSatellite 129W Notice Result. See FigureBell ExpressVU Operation Bell ExpressVU OverviewConfigure Bell ExpressVU Receiver Watching Bell ExpressVU programming Satellite Interface Menu Satellite Setup MenuChoose a Satellite Service Provider for Automatic Mode Main MenuManual Mode Press Select to select Manual Mode Returning to Automatic ModeTo Operate in Manual Mode Enter Sleep Factory DefaultSleep Menu ModeExit Sleep Mode Set Sleep TimeMenu Option Explanation Default SleepDiagnostics Menu Configuration Menu LCD Error Message Cause Solutions TroubleshootingLCD Error Messages Solutions to Common Operating Issues Symptom Winegard HD Satellite Interface Winegard HD Satellite Interface Secondary DirecTV HD Receiver Appendix C. Normal Operating Messages Service Provider Standard Receiver HD ReceiverAppendix B. Recommended Receivers Message Dish Status To ClearSatellite Receiver Warranty