2. SAFETY
2.1 Installation Safety:
Winegard highly recommends the Winegard HD Satellite Interface System be installed by a professional installer, as RV roof top work may be required, as well as some electrical wiring.
Do not install the roof top portion of this system in the rain. Before drilling any holes for installation, make sure there are no obstructions, such as wiring, etc. To protect against water damage, seal any roof top holes with approved sealant.
Read the entire manual before attempting to install the system. Follow the instructions carefully.
Use all appropriate safety equipment.
Winegard is not li- able for damage, expenses, or injury caused by improper installation.
3. INSTALLATION
3.1 |
| |
Installation Overview (order may change depending on installation) |
| |
Gather tools and equipment needed for installation. |
| |
Route new data/power cable, if necessary | Plan your entire installa- | |
Install HD Satellite Interface and necessary components | tion before you start. Determine | |
Connect Satellite Interface to antenna and receiver | the location of all of your equip- | |
Update satellite antenna software, if necessary | ment and make sure cable and | |
|
| wires are long enough to reach |
|
| their termination points. |
Tools and Material Required for Installation |
| |
1. | Drill |
|
2. | Phillips #2 Screwdriver or drill bit |
|
3. | 5/16” nut driver bit |
|
4. |
| |
5. | 7/16” |
|
6. | Sealant (check with your RV manufacturer for proper type) |
|
7. | Small flat head screwdriver |
|
Select a Location to Install the Satellite Interface | If you are installing a | |
For best results, the Winegard Satellite Interface should be installed near the primary | ||
new Satellite Antenna with | ||
receiver in your RV. Be sure an AC power source is available. | ||
the HD Satellite System, use | ||
| ||
| the cables supplied with this |
This manual assumes that a Winegard Satellite System is already fully installed on the kit for antenna installation. RV roof top. If a system has not yet been installed, please refer to the installation manual
included with the satellite system for installation instructions. Use the power/data cable included with this kit for satellite antenna installation.