Winegard WB-2700, WB-2000 Actual Screen may vary, Watching Bell ExpressVU programming

Select “Point Dish/Signal” option “1”. If you do not see signal on your meter, be sure satellite 91 is selected and try a different transponder. All transponders may not be active. See Figure 6.1.

Figure 6.1 - Actual Screen may vary

Select “Check Switch” from the Point Dish Screen.

Be sure that any options, such as “Alternate” are unchecked. Select “Test.”

The receiver will test the satellite antenna to verify which switch should be in- stalled. After the test is completed, the check switch screen will report the result.

The switch type installed should be “SW42”. If this switch is not installed cor- rectly, please run the check switch test again.

6.3 Watching Bell ExpressVU programming

Power on the Winegard Satellite Interface. In a few moments, the satellite antenna will begin its search routine. It will verify satellites and lock onto Dish Network satellite 91°W.

If you have an in-motion antenna, the antenna will continue to “track” the satel- lite for 7 minutes after signal acquisition. After 7 minutes, it will enter sleep mode. You can watch television as normal while the antenna is tracking. For instructions on how to force sleep mode, see Section 7.3.

23