ENGLISH
About the Remote Control Unit
Getting
Inserting the Batteries
q Remove the remote control w Set three AAA/R03 batteries in
Operating Range of the Remote Control | Remote Control Settings (Remote |
Unit | Control Side) |
Started
unit’s rear cover.the battery compartment in the indicated direction.
w
q
Batteries
e
ePut the rear cover back on.
NOTE
Point the remote control unit at the remote sensor when operating it.
Approx. 5 m
30° 30°
Switches when the UD9004’s remote control operates another MARANTZ BD players in the vicinity.
Set the remote control code simultaneously on the main unit, too. For how to set codes, see GUI menu: “Other Setup” – “Remote Control Setting” – “Remote ID” (vpage 32).
GRemote control code settingH
•The supplied remote control has two remote control code settings: BD 1 and BD 2.
•The code is set to “BD 1” at the factory.
•To set the code to “BD 2”, hold the Stop (2) button and the Number button [2] pressed for more than
•To set (return) the code to “BD 1”, hold the Stop (2) button and the Number button [1] pressed for more than
Connections Setup Playback HDMI Control
•Use AAA/R03 batteries in this remote control.
•Replace the batteries with new ones if the set does not operate even when the remote control unit is operated close to the unit. (The supplied batteries are only for verifying operation.)
•When inserting the batteries, be sure to do so in the proper direction, following the “q” and “w” marks in the battery compartment.
•To prevent damage or leakage of battery
Do not use a new battery together with an old one. Do not use two different types of batteries.
Do not attempt to charge dry batteries.
Do not
•If the battery
of the battery compartment and insert new batteries.
•Remove the batteries from the remote control unit if it will not be in use for long periods.
•Used batteries should be disposed of in accordance with the local regulations regarding battery disposal.
NOTE
The set may function improperly or the remote control unit may not operate if the remote control sensor is exposed to direct sunlight, strong arti
light.
•If the signal code of the remote control does not match the signal code of the unit, the remote control code set on the unit is shown on the display.
GExampleH
If the code setting on the unit is “BD 1”, and the setting on the remote control is “BD 2”, “BD 1” is shown on the display.
NOTE
Match the signal code of the remote control with the signal code of the unit. If the remote control code is different, you cannot operate the UD9004 with the remote control.
Function Information Troubleshooting Speci
7