Operations Enabled During Playback
Switching the Angle
ENGLISH
HDMI Control Function
Getting
BD
During playback of a BD or
1 Press ANGLE button during playback.
The angle number currently being played is displayed.
Angle
1/3
2 Use d, f buttons to select angle.
Angle
2/3
3 Press ANGLE button. The setup screen disappears.
NOTE
Angle changing may be restricted, depending on the disc.
Changing the Brightness of the Display (Dimmer Control)
Press DIMMER button.
The display brightness each time the button is pressed.
Normal 
Dim 
Dark 
Off
Even when “Off” is selected, the status of operations that are performed appears momentarily on the display if “Display Setup”
– “Temporary Display” on the GUI menu is set to “On” (vpage 32).
When you make an HDMI connection with a TV or AV Amp compatible with UD9004 and HDMI control functions, you can perform the following operations by setting the HDMI control function of each device.
n TV or AV Amp power is turned on by operating the UD9004, and functions change with UD9004 input.
n Turning off the TV’s power turns the UD9004’s power to standby.
n Operating the UD9004 via the TV’s remote control.
(When the TV’s remote control has player operation buttons)
NOTE
•The HDMI control function controls operations of a TV that is compatible with the HDMI control function. Make sure that the TV and HDMI are connected when you perform HDMI control.
•Some functions may not operate depending on the connected TV or AV Amp. Check the owner’s manual of each device for details beforehand.
•When “Other Setup” – “Power Saving” on the GUI menu is set to “Power Saving Standby” or “Normal Standby” (vpage 32), the player’s power cannot be turned on using the HDMI control function.
•When “HDMI Setup” – “HDMI Control” – “Power Off Control” on the GUI menu is set to “Off” (vpage 26), the UD9004 is not set to standby even if the connected device is in the standby mode.
1 Set the HDMI output terminal corresponding with the HDMI control function.
On the GUI menu, set “HDMI Setup” – “HDMI Control” (vpage 26).
b The HDMI control function will work only on one of the 2 HDMI output terminals on the UD9004.
2Turn the power on for all the equipment connected by HDMI cable.
3 Set the HDMI control function for all equipment connected by HDMI cable.
On the GUI menu, set the UD9004 with “HDMI Setup” – “HDMI Control” (vpage 26).
bPlease refer to the owner’s manual as regards setting of connected devices.
bCarry out Steps 2 and 3 should any of the equipment be unplugged.
4 To ensure that the UD9004’s HDMI video output is projected on the TV screen, change the input function of the TV and AV Amp.
5When you turn the TV’s power to standby, check that the power of the UD9004 and AV Amp also goes on
standby.
If the HDMI control function does not operate properly, check the following points.
•Is the TV or AV Amp compatible with the HDMI control function?
•Is the setting of the UD9004’s HDMI output terminal correct? (Step 1)
•Are the HDMI control function settings of all equipment correct? (Step 3)
•After setting, did you add another HDMI device connection or make any changes in the connections? In this case, perform setting again.
Started Connections Setup PlaybackPlayback HDMI Control Function Information Troubleshooting Speci
49