Video Setup, Hdmi Setup, Remote control operation

Getting Started Connections Setup Playback HDMI Control Function Information Troubleshooting Speci

ENGLISH

HDMI Setup

Setting items		Setting contents
SA-CD Audio Out		On : Super Audio CD audio is output.
Set to output	stereo/multi	Off : Super Audio CD audio is not output.
area audio of	Super Audio
CD to the HDMI terminal.		The Super Audio CD audio signal is a 44.1 kHz/16-bit Linear PCM output.

HDMI Control		GControlH
Can operate the unit in		• Off : Disable the HDMI control function.
conjunction with an HDMI		• HDMI1 On : Link with the device connected to HDMI1.
control support device.		• HDMI2 On : Link with the device connected to HDMI2.

•On : Turns the UD9004’s power to standby through linkage to the TV.

•Off : Does not turn the UD9004's power to standby through linkage to the TV.

•For the HDMI control function to operate, it is necessary for the UD9004 or HDMI-compatible TV connected to the UD9004 to have an HDMI connection.

•Refer to “HDMI Control Function” (vpage 49) for more information about the HDMI control function.

•After the “HDMI Control” setting has been changed, always turn off the power to the connected equipment and then turn it back on.

Default settings are underlined.

Set the video output signal according to the connected TV.

	Setting items					Setting contents
TV Aspect (Aspect ratio)						16:9 Squeeze Auto : Output to a wide screen TV. For 4:3 video, display in
Set the screen type and						the center of the screen without changing the aspect ratio.
display mode of the TV.						WIDE (16:9) : Output to a wide screen TV.
						4:3 PS : Output to a 4:3 TV. For wide video, trim the left and right side of
						the image and display in 4:3 aspect ratio. z1
						4:3 LB : Output to a 4:3 TV. Display all of the wide video. z2
Component Resolution						480/576i, 480/576P, 720P, 1080i,
Set the component				output		Source Direct : Output video using its source resolution. Convert the
resolution.						1080p video source to 1080i.
Progressive Mode						Auto : Detect the type of video material and automatically switch the
Set an appropriate progressive						mode. Normally, this setting is used.
conversion		mode for			the	Video1 : Suitable for playing video material discs.
source video material.						Video2 : Suitable for playing video material discs or 30-frame
						discs.
TV Active Area						Full : Set when a home-use monitor is connected.
Sets	the	horizontal		display		Normal : This setting is used when video synchronization is disturbed on
range	when		the	analog		a professional-use monitor.
video	output		resolution		is	This is not available for HDMI output.
480i/576i.						This is not available for HDMI output.
480i/576i.

z1 : Depending on the video content, even though you set the 4:3 PS (Pan Scan), the content may be output in 4:3 LB (Letter Box).

z2 : Only valid for content recorded in 480i/576i.

Remote control operation	SET UP	:Displaying the menu	d f 0 1	:Moves the cursor	ENTER :Decision the setting	RETURN :Return to previous menu
buttons		Cancel the menu		(Up/Down/Left/Right)