PROGRAM THE REMOTE
To cancel Code Search, press and hold CLEAR until the LED turns off.
There are 20 total sets of codes. If the device does not turn off after pressing PLAY 20 times, the remote cannot control that particular component.
If the component you want to control does turn off:
1.Press and release REVERSE, then wait two seconds. Repeat this step until the component turns back on. This means the remote has identified the correct code.
2.To finish, press and hold STOP until the LED turns off.
USING DIRECT ENTRY
Direct Entry is another way to program your remote if the Automatic Code Search is unsuccessful.
1.Turn on the component to be programmed.
2.Look up the brand and code number(s) for the component in the code list at the end of this section of the manual.
3.Press and hold the component button on the remote you want to program.
4.Enter the code from the list at the end of this section of the manual.
5.Release the button, and then press ON•OFF to see if the component responds to the remote commands. If it doesn’t, try pressing the component button and then ON•OFF again.
6.Repeat these steps using the next code listed for your brand if you get no response.
OPERATING COMPONENTS
After programming the remote, see which buttons operate your component.
1.Point the remote at the component, and press its corresponding button on the remote.
2.Experiment to see which buttons operate your component. Try pressing buttons that relate directly to the component like the volume buttons for a television or stereo receiver.
This remote may not operate all models and/or brands of components.
Note the difference between the VCR and other component’s
43