08Setting up
5Select “Sub Volume” (/).
6Select the desired volume level (/).
| Sound Effect |
|
|
|
|
| Headphone Output |
| Sub |
| |
| Sub Volume | 15 |
|
|
|
|
|
|
| ||
|
|
|
| ||
|
|
|
|
|
|
7 Press HOME MENU to exit the menu.
Note
•To adjust the volume for headphones after selecting “Sub”, always use “Sub Volume” from the menu, whether the screen is in single,
Power Control
Power Control provides convenient functions for power saving.
Energy Save
You may use one of the three Energy Save modes to save power consumption.
1Press HOME MENU.
2Select “Power Control“ (/ then ENTER).
3Select “Energy Save“ (/ then ENTER).
4Select “Mode1“, “Mode2“, or “Picture Off“ (/ then
ENTER).
Energy Save
Selections | Off | Provides normally bright pictures |
|
|
|
| Mode1 | Consumes less power than “Off” mode |
|
|
|
| Mode2 | Consumes less power than “Mode1” |
|
|
|
| Picture Off | Deactivates the screen to save power. To |
|
| restore the screen display, press any button |
|
| other than |
|
| Effect) or e. |
|
| This setting is not memorized by the system. |
|
|
|
5 Press HOME MENU to exit the menu.
Note
•When you change the Energy Save mode, you may notice a change in the panel sound. This is normal.
•The Energy Save function can maintain efficiency of the screen for a long period of time. Setting the Energy Save function to “Mode1” is recommended in order to maintain efficiency of the screen for a long period of time.
No Signal off (AV source only)
The system will be automatically placed into the standby mode if no signal is received for 15 minutes.
1Press HOME MENU.
2Select “Power Control“ (/ then ENTER).
3Select “No Signal off“ (/ then ENTER).
4Select “Enable“ (/ then ENTER).
No Signal off
Selections | Disable | Does not place the system into the standby |
| (default) | mode |
|
|
|
| Enable | Places the system into the standby mode if |
|
| no signal is received for 15 minutes |
|
|
|
5 Press HOME MENU to exit the menu.
Note
•Five minutes before the system is placed into the standby mode, a message appears every minute.
•The system may not be placed into the standby mode when noise signals are present at the plasma television after a TV programme finishes.
No Operation off (AV source only)
The system will be automatically placed into the standby mode when no operation is performed for three hours.
1Press HOME MENU.
2Select “Power Control“ (/ then ENTER).
3Select “No Operation off“ (/ then ENTER).
4Select “Enable“ (/ then ENTER).
No Operation off
Selections | Disable | Does not place the system into the standby |
| (default) | mode |
|
|
|
| Enable | Places the system into the standby mode if |
|
| no operation is performed for three hours |
|
|
|
5 Press HOME MENU to exit the menu.
Note
•Five minutes before the system is placed into the standby mode, a message appears every minute.
36
En