Panasonic BT-LH2550P, BT-LH2550E manual System Config

Main Menu (continued)

SYSTEM CONFIG

			Underlined values indicate factory defaults.
Sub menu	Settings	Description
B.LIGHT/CONT.	BACKLIGHT	Selects function to be assigned to BACKLIGHT/CONT. in the picture/
	CONTRAST	volume adjusting menu.
		<BACKLIGHT> Adjusts the BACKLIGHT.
		<CONTRAST> Adjusts the CONTRAST.
BACKLIGHT	0 - 50	Adjusts the backlight when the B.LIGHT/CONT. submenu is set to
		CONTRAST.
MENU	CENTER	Positions the on-screen menu.
POSITION	LB	<CENTER> Center of the screen
	RB	<LB> Left Bottom	<RB> Right Bottom
	RT
		<RT> Right Top	<LT> Left Top
	LT
STATUS	OFF	Sets display state for input signal status (on-screen menu).
DISPLAY	3SEC OFF	<OFF> Not displayed.
	CONTINUE	<3SEC OFF> Displayed for 3 seconds after a status change.
		<CONTINUE> Displayed at all times
SETUP LOAD	USER5*1*2	Loads saved factory defaults (FACTORY) or user data (USER1 - USER5).
	USER4*1*2	After loading user data, the screen displays the signal selected before
	USER3*1*2	user data was loaded.
	USER2*1*2
	USER1*1*2
	FACTORY
SETUP SAVE	USER5*2	Up to 5 sets of user data can be saved ( page 20).
	USER4*2	They save menu settings and adjustments made in the picture/volume
	USER3*2	adjusting menu (PHASE/CHROMA/BRIGHT/CONTRAST/BACKLIGHT)
	USER2*2
		except “SETUP SAVE/SETUP LOAD.”
	USER1*2
POWER ON	USER5	Selects the settings used when the power is turned on.
SETUP	USER4	<LAST> Starts in the mode used when the power was last turned off.
	USER3	<FACTORY> Starts up using the factory defaults.
	USER2
		<USER1 - 5> Starts up using USER registered settings.
	USER1
	FACTORY
	LAST
POWER SAVE	OFF	Sets the power save mode
MODE	ON	<OFF> Does not activate the POWER SAVE mode.
		<ON> The backlight dims when no signal (NO SIGNAL) is input for 60
		seconds or longer. Signal input or menu operation will return the
		backlight to its normal brightness.
CALIBRATION		Connect a CA-210 color analyzer and use this submenu to make a
		calibration. It also returns calibration data to factory defaults. ( page 30,
		31)
*1 When the monitor is shipped, settings for “USER1” - “USER5” are identical to “FACTORY.”
*2 “H POSITION”, “V POSITION”, “PHASE” and “CLOCK” (			page 37) cannot be saved or loaded.

29