3.2Disk Enclosure (Rear)
(2) Adapter (ADP1) |
| (2) Adapter (ADP0) |
|
|
|
(1) Power supply for disk enclosure (PS1) |
| (1) Power supply for disk enclosure (PS0) |
|
|
|
(1)Power supply for disk enclosure (PS0/PS1)
The power supply is intended to supply power to the additional disk enclosure. See Section 3.3 "Power Supply for Disk Enclosure".
(2)Adapter (ADP0/ADP1)
The adapter board is used to control the additional disk enclosure. See Section 3.4 "Adapter".
When inserting or replacing the power supply for the disk enclosure or an adapter into the disk enclosure, push it as far as it will go and then secure it with the screws.
Incorrect insertion may cause a power supply failure or adapter failure again.
When replacing a power supply for the disk enclosure, prepare the new power supply before removing the old one, and then replace it within about 3 minutes.
The following are heating units of the disk enclosure:
A)Disk drives
B)Power supplies for the disk enclosure
The fans in the power supplies for the disk enclosure serve as cooling fans for both of the above. Therefore, do not leave the disk enclosure with one of the power supplies removed. Doing so causes the disk drive temperature to rise, which may significantly decrease the reliability.
- 10 -