Directed Electronics 259D manual Directed electronics, inc

Page 19

Installing the hood pin switch requires drilling a ¼-inch hole in the metal lip under the hood. Choose a location that will allow the pin switch to be depressed when the hood is closed.

The pin switch has a connector on the bottom to connect to. Using a spade connector (included) strip back a ¾-inch section of the insulation and crimp the connector on to the wire. Pull on the connector to ensure a good connection.

Place the connector onto the pin switch and run the wire into the vehicle through a factory rubber grommet. Using a sharp, pointed object poke a hole into the grommet and attach the wire to the object with electrical tape. Pull the wire through the grommet taking extra care to keep the wire away from any moving parts or anything that will generate extreme heat. Once the wire is run into the vehicle and secured from any moving parts, solder the wire to the GRAY wire on the secondary wire connector and cover the connection with electrical tape.

important! Do not use the vehicle until you confirm the operation of the hood pin shutdown.

16

© 2002 directed electronics, inc .

Image 19
Contents 259D Limited lifetime consumer warranty Important Note Table of contents Installation tools What is includedImportant information System maintenanceFcc/id notice Your warrantyDirected electronics, inc Directed electronics, inc Primary harness H/1, 8-pin connector Secondary harness H/2, 6-pin connectorRelay satellite thick gauge wires Relay satellite ribbon harness H/3, 5-pin connectorInstallation Step Constant Power and Ignition wires Meter, turn the key to the crank position and the voltage Accessory and Starter wires Directed electronics, inc Safety Shutdown Wires Directed electronics, inc Directed electronics, inc Directed electronics, inc Parking light flash Door locks Engine monitoring Directed electronics, inc Directed electronics, inc Factory Alarm/Disarm Immobilizer Bypass Modules Testing the system Transmitter functions Standard configurationTransmitter/receiver learn routine Lock/Unlock Timer Mode Remote Start Locking/arming Using your systemIgnition-controlled door locks Unlocking/disarmingRemote start Step on the brake pedal, or Press and for one second Timer mode Valet take-over Features menu Rapid resume logic TroubleshootingProgramming options Directed electronics, inc Directed electronics, inc Directed electronics, inc Glossary of terms Security & convenience expansions Wiring quick reference guide Directed electronics, inc Directed electronics, inc Quick Reference Guide Company behind this system is Directed Electronics, Inc