Directed Electronics Official Manual for Universal Remote Programming

Page 25

enough to actually start the engine, it is possible to change the programming to extend the crank time. Refer to the Programming Options section of this guide.

On some vehicles the electrical system has too low of a voltage variance for the remote start module to see. In this case the engine will not be protected from over cranking, over revolution, or under revolution of the engine.

If this is the case, it will be necessary to locate a tachometer wire in the vehicle using the multi-meter. Identify the suspect wire according to the web information. Then start the vehicle with the key and place the black lead of the multi-meter on the nega- tive battery post and secure it. Put the multi-meter in the AC position and probe the suspect wire with the red lead of the multi-meter. With the engine at idle the multi-meter should read between .05 volts to 1.5 volts.

Have a second person press the gas pedal to increase the RPMs and watch the meter display. When the RPMs increase the

22	© 2002 directed electronics, inc .

Image 25

Contents 259D Limited lifetime consumer warranty Important Note Table of contents Installation tools What is includedImportant information System maintenanceFcc/id notice Your warrantyDirected electronics, inc Directed electronics, inc Primary harness H/1, 8-pin connector Secondary harness H/2, 6-pin connectorRelay satellite thick gauge wires Relay satellite ribbon harness H/3, 5-pin connectorInstallation Step Constant Power and Ignition wires Meter, turn the key to the crank position and the voltage Accessory and Starter wires Directed electronics, inc Safety Shutdown Wires Directed electronics, inc Directed electronics, inc Directed electronics, inc Parking light flash Door locks Engine monitoring Directed electronics, inc Directed electronics, inc Factory Alarm/Disarm Immobilizer Bypass Modules Testing the system Transmitter functions Standard configurationTransmitter/receiver learn routine Lock/Unlock Timer Mode Remote Start Locking/arming Using your systemIgnition-controlled door locks Unlocking/disarmingRemote start Step on the brake pedal, or Press and for one second Timer mode Valet take-over Features menu Rapid resume logic TroubleshootingProgramming options Directed electronics, inc Directed electronics, inc Directed electronics, inc Glossary of terms Security & convenience expansions Wiring quick reference guide Directed electronics, inc Directed electronics, inc Quick Reference Guide Company behind this system is Directed Electronics, Inc