Directed Electronics 259D manual Valet take-over

1.Start the engine by pressing and .

2.Press and release .

3.Within two seconds press and release and again.

4.The engine will shut down and the parking lights will flash four times to confirm that Timer Mode has been exited. If the car has already been remote started, skip Step One.

➜

valet take-over

The Valet® Take-Over feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the motor running and the climate controls on.

To perform Valet Take-Over:

1.Before turning off the engine, press and release and on the transmitter.

2.Turn the ignition key to the OFF position. The engine will stay running.

3.The engine will run until the pre-programmed time elapses or a shut-down input is received. (See the previous Remote Start section for a complete list of shut-down inputs.)

note: This feature will not work if the brake pedal is being pressed.

34 © 2002 directed electronics, inc .