Directed Electronics 259D manual Step on the brake pedal, or Press and for one second

Page 35

To remote start the vehicle:

1.Simultaneously press and on the transmitter for one second.

2.The parking lights will flash to confirm remote start opera- tion.

3.Once the vehicle has started, it will run for the pre-program- med period of time (12 or 24 minutes) or until a shutdown input is triggered.

When you are ready to drive the vehicle:

1.Insert the ignition key and turn it to the ON position.

2.Press the brake pedal.

note: If the brake pedal is pressed before the key is in the ON position, the engine will shut down.

While the vehicle is running during remote start operation, the system will monitor the vehicle and will automatically shut down the engine if the system receives any of the following shut- down inputs:

The brake pedal is pressed.

The hood is opened.

The shutdown toggle switch is put into the ON position.

The pre-programmed run time has elapsed.

Buttons and are pressed again.

To shut down the remote start and turn off the engine:

Step on the brake pedal, or

Press and for one second.

32

© 2002 directed electronics, inc .

Image 35
Contents 259D Limited lifetime consumer warranty Important Note Table of contents Installation tools What is includedImportant information System maintenanceFcc/id notice Your warrantyDirected electronics, inc Directed electronics, inc Primary harness H/1, 8-pin connector Secondary harness H/2, 6-pin connectorRelay satellite thick gauge wires Relay satellite ribbon harness H/3, 5-pin connectorInstallation Step Constant Power and Ignition wires Meter, turn the key to the crank position and the voltage Accessory and Starter wires Directed electronics, inc Safety Shutdown Wires Directed electronics, inc Directed electronics, inc Directed electronics, inc Parking light flash Door locks Engine monitoring Directed electronics, inc Directed electronics, inc Factory Alarm/Disarm Immobilizer Bypass Modules Testing the system Transmitter functions Standard configurationTransmitter/receiver learn routine Lock/Unlock Timer Mode Remote Start Locking/arming Using your systemRemote start Unlocking/disarmingIgnition-controlled door locks Step on the brake pedal, or Press and for one second Timer mode Valet take-over Features menu Programming options TroubleshootingRapid resume logic Directed electronics, inc Directed electronics, inc Directed electronics, inc Glossary of terms Security & convenience expansions Wiring quick reference guide Directed electronics, inc Directed electronics, inc Quick Reference Guide Company behind this system is Directed Electronics, Inc