Directed Electronics 259D manual Engine monitoring

Page 24

Repeat this process for the unlock wire but press the switch to the unlock position when testing. Once you have identified the correct wire, solder the LIGHT BLUE wire off the main connector to it and cover the connection with electrical tape.

note: Additional parts may be required to interface with certain door lock types.

step 7

Engine monitoring

During remote start the system will need to know what the engine is doing and how fast it is idling in order to determine if the car is running. The module does this by monitoring the voltage of the vehicle’s electrical system. When the vehicle is not running the electrical system should read approximately 12 volts and will increase up to 14.40 volts when running. The remote start system monitors the increase to prevent the starter from cranking when the vehicle is already running.

If the idle is too slow or too high, the system will shut down the engine to prevent damage. If the starter does not crank long

© 2002 directed electronics, inc .

21

Image 24
Contents 259D Limited lifetime consumer warranty Important Note Table of contents What is included Installation toolsSystem maintenance Important informationYour warranty Fcc/id noticeDirected electronics, inc Directed electronics, inc Secondary harness H/2, 6-pin connector Primary harness H/1, 8-pin connectorRelay satellite ribbon harness H/3, 5-pin connector Relay satellite thick gauge wiresInstallation Step Constant Power and Ignition wires Meter, turn the key to the crank position and the voltage Accessory and Starter wires Directed electronics, inc Safety Shutdown Wires Directed electronics, inc Directed electronics, inc Directed electronics, inc Parking light flash Door locks Engine monitoring Directed electronics, inc Directed electronics, inc Factory Alarm/Disarm Immobilizer Bypass Modules Testing the system Standard configuration Transmitter functionsTransmitter/receiver learn routine Lock/Unlock Timer Mode Remote Start Using your system Locking/armingUnlocking/disarming Ignition-controlled door locksRemote start Step on the brake pedal, or Press and for one second Timer mode Valet take-over Features menu Troubleshooting Rapid resume logicProgramming options Directed electronics, inc Directed electronics, inc Directed electronics, inc Glossary of terms Security & convenience expansions Wiring quick reference guide Directed electronics, inc Directed electronics, inc Quick Reference Guide Company behind this system is Directed Electronics, Inc