Sharp PN-V602 operation manual 13 E, Multiple monitor connection, Connecting Peripheral Equipment

TIPS

•The length of the signal cables or surrounding environment may affect the image quality.

•The screen may not display properly when using terminals other than PC DVI-D/AV DVI-D for the input mode. In this case, turn off the power to all the monitors connected in a daisy chain and then turn the power on again.

•When connecting monitors in a daisy chain set AUTO INPUT CHANGE to OFF.

•Video output is disabled in the following cases: When the power is turned off

When the monitor is in input signal waiting mode

10. LAN terminal

•You can control the monitor from a PC on a network by connecting a commercially available LAN cable between this terminal and a network.

11. External speaker terminals

•Be sure to use external speakers with an impedance of 6 Ω or greater and a rated input of at least 10 W.

1	2	3
	Approx.
	3-15/16 inch
	(10 cm)

1.Attach a speaker cable core (included with the PN-ZB02) to the end of the speaker cable connected to the monitor.

2.While pushing the tab, insert the tip of the cable.

3.Release the tab.

TIPS

•Be sure to connect the + and - terminals and the left and right speakers properly.

•Avoid short circuiting the + and - terminals.

12.Audio1 input terminals

13.Audio2 input terminals

•Set the audio input terminal to be used in each input mode in AUDIO SELECT on the OPTION menu.

14. PC RGB input terminals

•Set BNC of INPUT SELECT on the OPTION menu to PC RGB when using the PC RGB input terminals.

•Select the audio input terminal to be used in PC RGB of AUDIO SELECT on the OPTION menu.

15. AV component input terminals

•Set BNC of INPUT SELECT on the OPTION menu to AV COMPONENT when using the AV component input terminals.

•Select the audio input terminal to be used in AV COMPONENT of AUDIO SELECT on the OPTION menu.

•Cannot be used when D-SUB in INPUT SELECT on the OPTION menu is set to AV COMPONENT.

16. AV video input terminal

•Select the audio input terminal to be used in AV VIDEO of AUDIO SELECT on the OPTION menu.

•Cannot be used when D-SUB in INPUT SELECT on the OPTION menu is set to AV VIDEO.

17. AV S-video input terminal

•Select the audio input terminal to be used in AV S-VIDEO of AUDIO SELECT on the OPTION menu.

Connecting Peripheral Equipment

Multiple monitor connection

The monitors can be aligned and used as a large screen.

[Example]

Remote control sensor box

(Supplied with the PN-ZR01 (optional))

Second monitor	First monitor
Secondary	Primary
(Expansion unit)	(Main unit)
ID No.: 2	ID No.: 1
Third monitor	Fourth monitor
Secondary	Secondary
(Expansion unit)	(Expansion unit)
ID No.: 3	ID No.: 4

TIPS

•Connect the RS-232C cables in order, starting with the first monitor (primary monitor). If monitors are connected in a different order they may not be operable.

•Always install the remote control sensor box on the primary monitor.

■ Connection with video cable

May vary depending on the system being used.

If using the PC/AV DVI-D terminal, up to 5 monitors can be connected in a daisy chain. (When the PN-ZB02 is attached)

First monitor Second monitor

PC/AV DVI-D	PC/AV DVI-D	PC/AV DVI-D
input terminal	output terminal	input terminal

Digital signal (DVI) cables (commercially available)

To PC digital RGB output terminal

shows the signal flow

13 E