Sharp PN-V602 Specifications NDimensional Drawings, NPower management, NPOWER Limited See

Specifications

nDimensional Drawings

Note that the values shown are approximate values.

52-5/8 [1335.9]

Unit: inch [mm]

5-7/8

[149.3]

3-5/8

[92.3]

29-11/16 [754.2]

52-5/8 [1335.9]

Opening width (52-5/16 [1329.4])

Opening height (29-7/16 [747.7])

VESA holes *	7-7/8	7-7/8
	[200]	[200]

3-15/16 3-15/16

[100] [100]

7-7/8 [200]

When mounting the monitor, be sure to use a wall-mount bracket that complies with the VESA-compatible mounting method. SHARP recommends using M6 screws and tighten the screws.

Note that screw hole depth of the monitor is 3/8 inch (10 mm). Loose mounting may cause the product to fall, resulting in serious personal injuries as well as damage to the product. The screw and hole should come together with over 5/16 inch

(8 mm) length of thread. Use a bracket which has been approved for UL1678 standard, and which can endure at least 4 times or more the weight of the monitor.

nPower management

This monitor conforms to VESA DPMS and DVI DMPM. Both your video card and computer must support the same standard in

order for the monitor’s power management function to work.

DPMS: Display Power Management Signaling

DPMS	Screen	Power	Hsync	Vsync
		consumption*1
ON STATE	Display	510 W	Yes	Yes
STANDBY	No		No	Yes
		1.0 W*2
SUSPEND			Yes	No
	display
OFF STATE			No	No

*1 When PN-ZR01 (optional), or PN-ZB02 (optional) is not

connected.

*2 When AUTO INPUT CHANGE is set to OFF.

DMPM: Digital Monitor Power Management

DMPM	Screen	Power
		consumption*1
Monitor ON	Display	510 W
Active OFF	No display	1.0 W*2

nPOWER LIMITED (See page 24.)

MODE	Power consumption
MODE2	195 W
MODE1	310 W
OFF	510 W

Set to ensure maximum power consumption. (See page 55.)

nDDC (plug and play)

The monitor supports the VESA DDC (Display Data Channel) standard.

DDC is a signal standard for plug and play between monitors and computers. Information about resolution and other parameters is exchanged between the two. This function can be used if the computer supports DDC and it has been configured to detect plug-and-play monitors.

There are several types of DDC, depending on the communication method used. This monitor supports DDC2B.

E56