FUNAI CR320IL8 A owner manual 5Troubleshooting Guide

Page 23

TROUBLESHOOTING

5Troubleshooting Guide

If the unit does not perform properly when operated as instructed in this owner’s manual, check the following chart once before calling for service.

Symptom	Remedy
No power	• Be sure the power cord is plugged in.
	• If a power failure occurs, unplug the power cord for 30 minutes to allow the unit to
	reset itself.
No picture or sound	• Check if the power is on.
	• Check the outlet connection.
	• Check the antenna or cable connection to the main unit.
	• When the outside antenna is used, check the wire condition and connection.
	• View other TV channels. The problem might be limited to the broadcasting station.
	• Turn off the power and wait for about 1 minute, then turn it on again.
No color	• Check the antenna or cable connection to the main unit.
	• When the outside antenna is used, check the wire condition and connection.
	• View other TV channels. The problem might be limited to the broadcasting station.
	• Adjust the “COLOR” in the main menu.
Sound OK, picture poor	• Check the antenna or cable connection to the main unit.
	• When the outside antenna is used, check the wire condition and connection.
	• Electrical interference from nearby appliances may affect picture quality.
	• Adjust “CONTRAST” and “BRIGHT” in the main menu.
	• View other TV channels. The problem might be limited to the broadcasting station.
Picture distorted	• When the outside antenna is used, check the wire condition and connection.
	• View other TV channels. The problem might be limited to the broadcasting station.
Weak picture	• Check the antenna or cable connection to the main unit.
	• When the outside antenna is used, check the wire condition and connection.
	• Adjust “CONTRAST” and “BRIGHT” in the main menu.
	• View other TV channels. The problem might be limited to the broadcasting station.
Lines or streaks in picture	• When the outside antenna is used, check the wire condition and connection.
	• Electrical interference from nearby appliances may affect picture quality.
	• View other TV channels. The problem might be limited to the broadcasting station.
Picture blurred	• When the outside antenna is used, check the wire condition and connection.
	• View other TV channels. The problem might be limited to the broadcasting station.
Ghosts in picture	• Check the antenna or cable connection to the main unit.
	• When the outside antenna is used, check the wire condition and connection.
	• Electrical interference from nearby appliances may affect picture quality.
	• View other TV channels. The problem might be limited to the broadcasting station.
Bars on TV screen	• When the outside antenna is used, check the wire condition and connection.
	• Electrical interference from nearby appliances may affect picture quality.
Picture rolls vertically	• When the outside antenna is used, check the wire condition and connection.
	• Electrical interference from nearby appliances may affect picture quality.
	• View other TV channels. The problem might be limited to the broadcasting station.
Different color marks on	• Move the unit away from nearby electric appliances. Turn off the power and wait
TV screen	30 minutes before turning it back on.
	• View other TV channels. The problem might be limited to the broadcasting station.
Poor reception on some	• Check the antenna or cable connection to the main unit.
channels	• When the outside antenna is used, check the wire condition and connection.
	• Electrical interference from nearby appliances may affect picture quality.
	• View other TV channels. The problem might be limited to the broadcasting station.
Picture OK, sound poor	• View other TV channels. The problem might be limited to the broadcasting station.

No reception of digital signals	• Make sure auto channel scan has been completed. (Refer to “Auto Channel Scan”
	on page 11.)
	Auto channel scan must be completed when you set up the unit for the first time
	or move it to a location where previously unavailable channels are broadcast.
	• The selected channel may not be broadcasting.
	• When auto channel scan is interrupted and not completed, some channels will not
	be received. Make sure to complete. (Refer to “Auto Channel Scan” on page 11.)

INTRODUCTION CONNECTION INITIAL SETTING WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION

23

EN

Image 23

Contents CR320IL8 a Important note is located on the rear of the cabinet IntroductionRADIO-TV Interference PrecautionsTo Avoid the Hazards of Electrical Shock and Fire 5Supplied Accessories5Symbols Used in this Manual LocationDTV/TV/CATV FeaturesContents 5Installing the Batteries 5Remote Control Function5Rear Panel 5Control PanelConnection to Cable Box or Satellite Box Connection5Basic Connection Antenna Cable ConnectionVideo Cable Connection Front 5External Device ConnectionComponent Video Cable Connection Video or Video Cable Connection Rear5Main Menu Initial Setting5Initial Setup English VOL Español Français 5Auto Channel Scan5Language Selection Press Menu to display the main menu5Channel Selection 5Volume AdjustmentWatching TV 5Switching Audio Mode 5Switching Each ModeProgram Guide 5Screen InformationPress Info Broadcasting InformationZoom 5TV Screen Display Mode5Sleep Timer LetterboxUse VOL X/Y to select ADD or Delete Optional Setting5Channel Add/Delete Press Menu to display the main menu Press Menu to exit5Closed Caption 5Picture AdjustmentDtvcc Use CH K/L to select DTVCC, then press VOL Digital TV mode5DTV Closed Caption Fore COLOR, Back Color 5DTVCC StyleFont Style Character EdgeDpage Change PasswordChip TV Rating DpageTV-14 To Set the Sub RatingsRating Category TV-Y7NC-17 Enter password again in Confirm Password spacePG-13 5Troubleshooting Guide TroubleshootingWith a digital camera including built-in cell phone cameras MaintenanceCamera, the remote control is working With an AM radioInformation Limited Warranty Manual del Usuario Introducción Importante para su SeguridadInterferencia DE RADIO-TELEVISIÓN PrecaucionesPilas AA x 2 para el mondo a distancia no incluidas 5Accesorios Suministrados5Símbolos Utilizados en este Manual Manual del usuarioContenido Características5Instalación de las Pilas 5Función de Mando a Distancia5Panel Trasero 5Panel de ControlConexión a Caja de Cable o Caja de Satélite Conexión5Conexión Básica Conexión de Cable de AntenaConexión de Cable de Vídeo Delantera 5Conexión de Dispositivo ExternoConexión de Cable de Vídeo en Componentes Conexión de Cable de S-video o de vídeo Trasera5Menú Principal 5Configuración InicialAjuste Inicial Presione Menu para salir Presione Menu para visualizar el menú principalUtilice CH K /L para seleccionar IDIOMA, y luego Repetidamente para cambiar el Ajuste Ej. modo TV digitalPara utilizar los botones numéricos 5Ajuste de VolumenPara VER LA Televisión 5Selección de CanalMono Main 5Para Cambiar entre Cada ModoModo Analógico Modo DigitalInformación de Emisión 5Información de PantallaPresione Info Para borrar la pantalla, presione Info nuevamenteAncho Buzón Para Cancelar el Temporizador de Apagado5Modo de Visualización de Pantalla del Televisor 5Temporizador de ApagadoPara agregar o borrar otros canales, repita los pasos Ajuste Opcional5Agregar/Borrar Canales Utilice VOL X/ Y para seleccionar Agregar o BorrarSUBTIT2 C2 y TEXTO2 T2 5Ajuste de ImagenOFF Modo de SubtítulosUtilice CH K/L para seleccionar DTVCC, y luego presione VOL 5Subtítulos Cerrados en DTV5Estilo Dtvcc Clase de Mpaa Cuando no haya configurado su contraseña, introduzcaClase de TV Categoría Clasificación Para Ajustar las SubcategoríasEj. TV-PG PG-13 No apto para niños menores de 13 años Vuelva a introducir la contraseña en el espacioClasificación Categoría Se sugiere orientación de los padres5Guía de Solución de Problemas Solución DE ProblemasCon una cámara digital MantenimientoCon una radio AM Información Garantía Limitada