BenQ LW61ST, LX60ST IP Address, Wired LAN Subnet Mask, Default Gateway, DNS Server, Apply, Hour

Page 41

Main menu	Sub-menu		Options

	Baud Rate		2400/4800/9600/14400/19200/
	Baud Rate		38400/57600/115200
			38400/57600/115200
	Test Pattern		On/Off
		Closed Caption	On/Off
	Closed Caption	Enable	On/Off
	Closed Caption	Enable
		Caption Version	CC1/CC2/CC3/CC4
		Network	On/Off
		Microphone	On/Off
	Standby	Monitor Out	On/Off
	Settings
	Settings	Audio Pass	Off/Computer1/Computer2/
		Audio Pass	Video,S-Video/HDMI/Network
		Through	Video,S-Video/HDMI/Network
		Through	display/USB display
			display/USB display
			Status
			DHCP
5.			IP Address
5.		Wired LAN	Subnet Mask
SYSTEM			Default Gateway
SETUP:			DNS Server
Advanced			Apply
			Status
			SSID
	Network	Wireless LAN	SSID Display
	Network		Connection Mode
	Settings		Connection Mode
	Settings		Apply
			Apply
			Account
		Remote Desktop	Password
			Connect
		Broadcasting	On/Off
		Projection Log In	On/Off
		Code
		AMX Device	On/Off
		Discovery	On/Off
		Discovery
		Mac Address
	Reset All Settings
			•	Source
6.			•	Picture Mode
6.			•	Resolution
INFORMA	Current System Status		•	Color System
TION			•	Equivalent Light Source
			Hour
			•	Firmware Version

Note that the menu items are available when the projector detects at least one valid signal. If there is no equipment connected to the projector or no signal detected, limited menu items are accessible.

Operation 41

Image 41

Contents LX60ST/LW61ST Table of contents Safety Instructions Important safety instructions3000 m Feet This apparatus must be earthed Ceiling mounting the projector Introduction Projector featuresShipping contents Rear/lower side Projector exterior viewFront/upper side Controls and functions Network Setting Enters network setting directly Test Remote controlSource selection buttons COMPUTER-1, COMPUTER-2 Keystone/Arrow buttons / Up DownOperating the Laser pointer VOLUME+/VOLUME- Adjusts the sound level MuteMIC/VOL + Numeric buttonsOperating the projector from Front Rear Remote control effective rangeReplacing the remote control batteries Choosing a location Positioning your projectorFront Table Front CeilingObtaining a preferred projected image size Projection dimensionsLW61ST Connection ConnectionPlaying sound through the projector Connecting video source devicesConnecting audio Device About the microphone inputStarting up the projector OperationAdjusting the projection angle Adjusting the projected imageAuto-adjusting the image Fine-tuning the image clarityCorrecting keystone Highlight Using the menusUtilizing the password function Using a security cable lockSetting a password Highlight Change Security Settings and press MODE/ENTERChanging the password If you forget the passwordEntering the password recall procedure Disabling the password function Changing Color Space Switching input signalSelecting the aspect ratio Magnifying and searching for detailsAbout the aspect ratio Selecting a picture mode Using Wall ColorSetting the User 1/User 2 mode Go to the Picture Picture Mode menuAdjusting Brilliant Color Fine-tuning the image quality in user modes3D Color Management Top-Left Bottom-Left Top-Right Bottom-Right Setting the presentation timerSelection Description Remote paging operations To cancel the timer, perform the following stepsFreezing the image Hiding the imageUsing the remote control To activate the High Altitude ModeLocking control keys Operating in a high altitude environmentAdjusting the sound level Adjusting the soundAdjusting the microphone volume Turning off the Power On/Off Ring TonePresenting from a USB Reader When viewing thumbnailsSupported image formats To view your pictures as a slide show, follow these stepsSetting Direct power offPress Power or OFF a second time. The Power indicator light Shutting down the projectorMenu system Menu operationMain menu Sub-menu Options BasicAdvanced Default Gateway Wired LAN Subnet MaskIP Address DNS ServerDescription of each menu Temperature Picture ModeManagement Save Settings Display menu Picture menu Function Description TeachingTimer System Setup Basic Function Description Quick AutoSettings SearchReceiver AdjustmentsPanel Key LockBaud Rate System Setup Advanced menu Function DescriptionTest Pattern ClosedNetwork Reset AllCurrent SystemCare of the projector MaintenanceLight source information Setting Light Source Mode Selection as EconomicGetting to know the light source hour Extending light source lifeStatus Message Timing of replacing the light sourceReplacing the light source Thermal events IndicatorsLight Status & Description Power events Troubleshooting Projector specifications SpecificationsMinimum installation requirements DimensionsWall mount installation Wxga Ceiling mount screw Minimum Ceiling Height mm = f + H + b + 60 + 274+ cSupported timing for PC input Timing chartKHz Supported timing for Hdmi Hdcp inputTiming Supported timing for Component-YPbPrinputSupported timing for Video and S-Video inputs Limited warranty Warranty and Copyright informationCopyright Disclaimer