Wayne-Dalton 9800 installation instructions Drum Wrap Installation, Rear Support

30	Drum Wrap Installation	Drum
		Wrap
Tools Needed:	Drum wraps are identified as right and	Outside
	left hand.
None		Flange
	To install, place the right hand drum
	wrap over the cable drum and under
	the idrive® disconnect cable. Align the
	outside flange over the outside edge of	Cable
	the cable drum and push the drum
		Drum
	wrap down onto the cable drum. Repeat
	for left hand side.
	NOTE: Drum wraps must be installed to
	prevent cable from becoming tangled.	Drum
	IMPORTANT: Right and Left hand	Wrap
	is always determined from inside
	the garage looking out.
		Cable
		Drum

31	Rear Support
		DOOR IN THE
Tools Needed:	WARNING	UP POSITION
Ratchet Wrench	Keep horizontal track parallel
	and within 3/4” maximum of door
1/2” Socket	edge, otherwise door could fall,
	resulting in severe injury or death.
1/2” Wrench	Raise the door until the top section and
	half of the next section are in a horizontal
(2) Vice Clamps	position. Do not raise door any further
	since the horizontal track are not yet
Level	supported at the rear.
	WARNING
Hammer		3/4”	vice
	Raising door further can result
			clamps
Tape Measure	in door falling and cause severe
	injury or death.
	Clamp a pair of vice clamps on the vertical	Door edge
	tracks just above the second roller on one
	side, just below the second roller on the		vertical
	other side. This will prevent the door from		TRACK
	raising or lowering while installing the rear
	support.
	Using perforated angle, 5/16” x 1-5/8”	horizontal
		track
	hex head lag screws and 5/16” bolts
	with nuts (may not be supplied), fabricate
	rear support for horizontal tracks. Attach

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local31 yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com

INSTALLATION