Wayne-Dalton 9800 Level and parallel with door, Adjust weather seal or door stop if

	Rear Support Continued...
	horizontal tracks to the rear supports with	Sound Framing Members
Tools Needed:
	5/16”-18 x 1-1/4” hex bolts and nuts (may
	not be supplied). Horizontal tracks must be
	level and parallel with door.
	NOTE: If rear supports are to be installed
	over drywall, use 5/16” x 2” hex head lag		perforated ANGLE
	screws.	angle
			- BOLTED USING (2) 5/16”
	NOTE: If an idrive® opener is installed,
		brace
	position horizontal tracks one hole above		X 1-5/8” HEX HEAD LAG
			SCREWS TO CEILING
	level when securing it to rear supports.
	Adjust weather seal or door stop (if		MEMBER AND PARALLEL
	necessary). Now permanently attach the		TO DOOR
	weather seal or door stop to both door
	jambs and header. (They were temporarily	HORIZONTAL TRACK	BOLT MUST EXTEND INTO
	attached in PREPARING THE OPENING on		THE TRACK TO SERVE AS
	page 10.) Avoid pushing weather seal or		A ROLLER STOP
	door stop too tightly against face of door.
	WARNING	Sound Framing Members
	Prior to winding or making
	adjustments to the springs,
	ensure you’re winding in the
	proper direction as stated in the
	Installation Instructions. Otherwise		perforated ANGLE -
	the spring fittings may release from	angle	BOLTED USING (2) 5/16”
	spring if not wound in the proper
		brace	X 1-5/8” HEX HEAD LAG
	direction and could result in severe
			SCREWS TO CEILING
	or fatal injury.
			MEMBER AND PARALLEL
	Now, lift door and check it’s balance.		TO DOOR
	Adjust, if door lifts by itself (hard to pull	HORIZONTAL TRACK
	down) or if door is difficult to lift (easy to		BOLT MUST EXTEND INTO
	pull down). Anytime spring adjustments are		THE TRACK TO SERVE AS
	made you must loosen the lock nuts before		A ROLLER STOP
	beginning adjustments. Retighten both lock	PERFORATED ANGLE
	nuts after completion. To adjust spring(s),
	only add or remove 1/4 turn on the counter
	at a time. Adjust both sides equally.
	IMPORTANT: Do not add or remove
	more than 1 spring turn from		weather
	specified amount. If the door still
			seal
	does not operate easily, lower the
	door to the closed position, UNWIND
	SPRING(S) TO ZERO, and recheck the
	following items:		jamb
	1.) Check the door for level.
	2.) Check the TorqueMaster® spring tube	(3) 5/16”
	and flagangles for level and plumb.	BOLTS & NUTS	permanently attached
	3.) Check the distance between the
			weather seal
	flagangles - must be door width
	plus 3-3/8” to 3-1/2”.
	4.) Check the counterbalance cables
	for equal tension - adjust if necessary.
	5.) Rewind the spring(s).
	6.) Make sure door isn’t rubbing on jambs.

NOTE: As a safety feature, the right hand end bracket cannot be disassembled for service until the spring is completely unwound and the counter cover reads zero. After door installation is completed, refer to the idrive® owner’s manual to complete the idrive® installation.

32 Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com