301 IN/OUT DEL, NON-STD Servo REF, Std, Ext

Setup menus

USER menu	<EDIT>
	<EDIT>
		Item
	No.	Superimposed
	No.	display
		display

300 VAR RANGE

301 IN/OUT DEL

Setting

No. Superimposed display

0000 – 0.43 – 1

0001 –4–+4

0000 MANU

0001 AUTO

Description

This sets the VAR speed range.

0:The tape is played in slow motion at a speed ranging from

–0.43 × to +1 × (or from – 0.5 × to +1 × for the DV format) normal speed.

1:The tape is played in the ±4.1 × normal speed range.

<Note>

Phase synchronization from the editing controller is no longer possible once this item has been set to “0”.

For DV format:

When using the dial on the front panel, playback is always performed at – 0.5 to +1 × normal speed regardless of the menu setting.

When using the 9P (RS-232C), when 0 is selected, playback is performed at – 0.5 to +1 × normal speed.

When 1 is selected, playback is performed at – 3.1 to +3.1 × normal speed.

This selects the operation to be performed when an edit point has been set incorrectly (when the OUT point is before the IN point).

0:Editing is not executed unless the illegal edit point is cleared or set again properly.

1:The edit points already input are automatically cleared.

302 NEGA FLASH

303 STD/

NON-STD

304 SERVO REF

305 EDIT RPLCE1

0000	OFF This selects whether to show a negative display when the IN
0001	ON point is greater than the OUT point.
		0: No negative display.
		1: Negative display.
0000	AUTO This selects STD or NON-STD in accordance with the
0001	STD	composite input signal..
0002	N-STD	0: Standard/non-standard signals are automatically identified
		and processed.
		1: Standard signals are processed. (Forced STD)
		2: Non-standard signals are processed. (Forced NON-STD)
0000	AUTO This selects the video signal processing.
0001	EXT	0: Servo is synchronized with the input signal during recording
		and editing, or with the REF signal during playback.
		1: Servo is synchronized at all times with the REF signal.
0000	N-DEFThis sets the channel assignments for the controller’s analog
0001	CH1 audio preset when editing the digital audio of the VTR using a
0002	CH2 controller which does not have a digital audio edit preset
0003	CH1+2	control function.

This selects the channel concerned when the VTR CH1 edit preset is set in compliance with the ON or OFF presetting for the analog audio signals designated by the controller.

0: Not set.

1: Compliance with analog CH1 edit preset.

2: Compliance with analog CH2 edit preset.

3: Compliance with either analog CH1 or CH2 edit preset.

The underline on the setting item denotes the initial setting.

- 4 9 -

Setup menus

USER menu

<EDIT>