Panasonic AJ-D750P manual Signal Pin No, Pin No Signal

Connector signals

PARALLEL REMOTE (25P)

Pin No.	Signal	Pin No.	Signal	Pin No.	Signal
1	PLAY COMMAND	10		19	STAND BY ON STATUS
2	STOP COMMAND	11	> 10V, MAX 300mA	20	PREROLL STATUS
3	FF COMMAND	12		21	SERVO LOCK STATUS
4	REW COMMAND	13	PLAY STATUS	22
5	REC COMMAND	14	STOP STATUS	23
6	EJECT COMMAND	15	FF STATUS	24
7	STANDBYON/OFFCOMMAND	16	REW STATUS	25	GND
8	PREROLL COMMAND	17	REC STATUS
9	IN SET COMMAND	18	EJECT STATUS

<Notes>

COMMAND pins: TTL level, active low, > 100ms edge electrical signal.

=

STATUS pins: open collector, sink current 6mA

RS-232C REMOTE (25-pin D-SUB crossover cable supported)

Pin No.	Abbreviation	Circuit		Description
1	FRAME GROUND	Protective ground		Frame ground
2	RxD	Received data		Sends data to the PC.
3	TxD	Transmitted data		Receives data from the PC.
4	CTS	Clear to send		Shorted with pin 5.
5	RTS	Request to send		Shorted with pin 4.
6	DTR	Data terminal ready		No processing
7	GND	Signal ground		Signal ground
20	DSR	Data set ready		Positive power output after communication enable
				status
Example of connections with controller (PC) using a 25-pin D-SUB crossover cable
PC end (D-SUB 25 pins)		VTR end (D-SUB 25 pins)
FG	1	1	FG
TxD	2	2	RxD
RxD	3	3	TxD
RTS	4	4	CTS
CTS	5	5	RTS
DSR	6	6	DTR
GND	7	7	GND
DTR	20	20	DSR

ENCODER REMOTE (15P)

Pin No.	Signal	Pin No.	Signal	Pin No.	Signal
1		6	SYSTEM H 0	11	RET GND
2	SET UP	7	SYS.SC COARSE (2)	12
3	C LEVEL	8	–12V	13
4	GND	9	HUE	14	SYS.SC FINE
5	+12V	10	VIDEO LEVEL	15	SYS.SC COARSE (1)

- 68 -