Panasonic AJ-D750P manual Rec Cue, PB Fade, Fine, ST2, Auto, Cut

USER menu

<AUDIO> (continued)

Item

No. Superimposed display

716 REC CUE

717SCALE DISP

718DV OUTPUT

719 PB FADE

720EMBEDDED AUD

	Setting	Description
No.	Superimposed
	display
0000	CUE This selects the input signal recorded in CUE.
0001	CH1	0: CUE IN
0002	CH2	1: Audio CH1 input
0003	CH1+2	2: Audio CH2 input
		3: Audio CH1 and CH2 MIX signal
0000	FULL This selects the level meter scale.
0001	FINE	0: Full scale.
		1: Fine scale.
0000	ST1 This selects the AUDIO CH1 and CH2 output signals during
0001	ST2	DV format playback.
0002	ST1+2	0: The CH1 track signals are output to CH1 and the CH2
		track signals to CH2.
		1: The CH3 track signals are output to CH1 and the CH4
		track signals to CH2.
		2: The mixed CH1 and CH3 track signals are output to CH1
		and the mixed CH2 and CH4 track signals to CH2.
		<Note>
		This item setting is valid only when the tape recorded on the
		four channels of the DV format is played back.
0000	AUTO	This selects the processing method for the audio edit points
0001	CUT	(IN point, OUT point) during playback.
0002	FADE	0: According to the status during recording.
		1: Forced CUT
0000	OFF	2: Forced FADE
		This selects whether to superimpose the audio data onto the
0001	ON	serial output.
		0: Data is not superimposed.

1: Data is superimposed.

<Note>

This item is valid when the optional serial interface board has been installed.

The underline on the setting item denotes the initial setting.

- 5 7 -