REMOTE CONTROL
The remote control is used for most of the operations and features of the VCR. Before proceeding, install batteries into the remote and get familiar with the buttons on the remote.
SIGNAL TRANSMISSION WINDOW
Transmits an invisible light beam from the Remote Control to the VCR.
"POWER" ON/OFF BUTTON
Press to turn VCR on. Press again to turn VCR off.
Aim the remote control at the receiver on the front
panel of the VCR.
NOTES:
1.If the range is short, try new batteries.
2.An object between the VCR and remote control may block the invisible light beam and operation
TRACKING/CHANNEL SELECT BUTTONS
•"AUTO" TRACKING: When playback is started, the auto tracking function operates and adjusts tracking automatically so the picture is optimized.
"AUTO TRK" flashes on the TV screen for several seconds.
•MANUAL "TRACKING"/"CHANNEL" SELECT
("V" and "A ") BUTTONS
"TRACKING": If noise appears on the screen during playback, press "V" or "&" button until the noise on the screen is reduced or eliminated.
"CHANNEL": You can scan up or down through all the memorized channels using the Channel Select button (V or A).
NOTES:
•Tracking is automatically reset to normal when a tape is inserted or the power cord is unplugged.
•Auto tracking may not operate correctly when the tape is scratched or the recorded condition is
poor.
In this case, press the TRACKING control button (V or A) to adjust tracking.
•If the AUTO TRACKING button is pressed after operating the TRACKING control button (V or A), auto tracking operates again.
NORMAL OPERATION BUTTONS
These buttons (except for "STOP" button) function same as the buttons on the front of your VCR.
•"STOP" BUTTON
If this button is pressed while the set is operating,
the running of tape stops and all operating modes are cancelled.
POWER
TUiAV TVNCR
CHANNEL/
TRACKING
PLAY
MENU CLEAR DISPLAY
@®@
®®®
@®®
@P,',-nEP
CLOCK/
VISS COUNT RESET
© © ©
REMOTE CONTROL
J