Goldstar R-E21M owner manual Time, Clock Setting Notes

Set the hour by pressing two number buttons on the remote control and two more for the minute

(for example, 0 2 15 for 2:15). The display prompts you to select AM or PM.

OPress "1" for AM or "2" for PM (for example, 2 for PM).

The display flashes and prompts you to set the date.

OSet the date by pressing six digits in order of month, day and year (for example 09 01 93 for September 1, 1993). The day of the week will appear when you have entered all six digits for the date.

NOTE: Always press "0" before single-digit months and days.

•The VCR will not accept illogical time or date entries (13th month for example).

•Now the display on the screen will show the correct time.

Press "MENU" button. The display resumes the "original menu".

CLOCK SET

TIME 02:15,_--!-_

A I P./I"

TO END PUSH MENU

CLOCK SET

TIME 02:15 PM

MONTI-_A)f/YEAR

DATE _;4 --I.::

TO END PUSH MENU

CLOCK SET

TIME 02:15 PM

MONTH/DAY/YEA R

DATE 09/01/93

WED

TO END PUSH MENU

PUSH SELECTION NUMBER

1 CLOCK SET

2 NORMAL PROGRAM

3 DAILY PROGRAM

4 WEEKLY PROGRAM

5 PROGRAM REVIEW

6 SET UP

TO END PUSH MENU

_) Press "MENU" button once again to return to the TV screen. To display the date and time, press the DISPLAY button.

CLOCK SETTING NOTES:

1.The clock must be set to the correct time before programming the timer for unattended recording.

2.When moving the VCR, if the power cord is reconnected within a few seconds (about 3 seconds), there is no need to reset the clock.

3.If a power failure lasts more than a few seconds, or if the power cord is disconnected for longer than a few seconds, the clock needs to be reset.

- 22 -