Goldstar R-E21M owner manual Antennancr Connections, Antenna with Separate VHF-UHF Leads, Vcr

ANTENNANCR CONNECTIONS

ANTENNAS WITH ONE LEAD (Combined VHF-UHF)

VCR

	"	"=	!-!	lilllllll
	:-_-_			nnoooooooIll
i		_A	®'®	_	III
75-ohm Comdal (round) Cable		To "IN FROM ANT"

300-ohm Twin-lead Flat Cable

ntenna Adaptor (300-ohm to 7S-ohm) (not aupplled)

,.,,,, i.

1.Disconnect the antenna leads from the rear of the "IV receiver.

2.Identify the type of cable from your antenna. If it is a round cable as illustrated, it is a 75-ohm coaxial antenna cable. This cable will connect directly to the connector marked "IN FROM ANT" on your VCR.

If your antenna lead wire is a flat type antenna cable, connect it to the Antenna Adaptor (300-ohm to 75-ohm) (not supplied) and slip the Adaptor onto the "IN FROM ANT" terminal. The Adaptor does not screw onto the VCR, it just slips over the connector.

ANTENNA WITH SEPARATE VHF-UHF LEADS

VCR

VHF Antenna UHF Antenna

To "IN FROM ANT"

t		hm Twin-lead Flat Cable
I
i r rr	i ii ii	-I__

Antenna Mlxer (VHF/UHF 300-ohm to 75-ohm) (not supplied)

1.Disconnect the UHFNHF twin leads on your tele- vision.

2.Locate Antenna Mixer(VHF/UHF 300-ohm to 75- ohm) (not supplied).

3.Connect the VHF Twin-lead Cable to the "VHF" terminals on the Antenna Mixer.

4.Connect the UHF Twin-leadCable to the "UHF" terminals on the Antenna Mixer.

5.Slip the Antenna Mixer onto the "IN FROM ANT" terminal.

-6-