JVC LPT0320-001B, HR-S9700EK setup guide Insert Editing, Locate END Point, Reset the Counter

54ADVANCEDOPERATIONS(cont.)

Insert Editing

Recorder Your recorder

Insert editing replaces part of the recorded scene with new material. Both the picture and Hi-Fi audio soundtrack are replaced with new ones, while the normal audio soundtrack remains unchanged. If you wish to change the normal audio track as well, use the audio dubbing function simultaneously. Use your video recorder as the recorder.

ATTENTION:

Insert editing is not possible with a cassette recorded in EP mode.

Source tape

S-Video signal Audio/Video signal

Another recorder

Player

JOG

8

13

2

SHUTTLE

4	5	6	3
7	8	9	4
			4
0000	0		AUX
1			3
2

PR

	Before insert editing	Normal audio
Recorded tape		track
	After insert editing
		Video/Hi-Fi
		audio track

MAKE CONNECTIONS

1 Connect the player's VIDEO OUT or S-VIDEO OUT and AUDIO OUT connectors to your recorder's VIDEO or S-VIDEO and AUDIO input connectors on the front panel.

SET INPUT MODE

2 Press AUX and/or PR so that "F-1" for the VIDEO/ AUDIO input connectors or "S-1" for S-VIDEO/AUDIO input connectors appears in place of a channel number.

LOCATE END POINT

3 Load the recording cassette into your recorder, and play it back to determine the edit-out point (the end of the segment to be replaced) using the SHUTTLE ring or the JOG dial or pressing @#and PAUSE.

RESET THE COUNTER

4 Press 0000 to change the counter display to "0:00:00".

LOCATE START POINT

5 Determine the edit-in point (the beginning of the segment to be replaced) using the SHUTTLE ring or the JOG dial or pressing @#and PAUSE.

●Be sure to engage the Still mode at the edit-in point.

PAUSE