42 EN | SUBSIDIARY SETTINGS (cont.) |
Set Stations (A)
Set station names that are registered in your recorder.
Perform steps 1 and 2 of “Manual Channel Set” on page 40 to access the Confirmation screen before continuing.
A Select the item.
Press rt w e until the item you want begins blinking.
B Access the Manual Channel Set screen.
Press OK twice.
C Select the new station.
Press e until the station name (ID) begins blinking, then press rt until the new station’s name (ID) you want to store begins blinking. Registered station names ( pg. 43) appear as you press rt.
B Enter the new character.
Press rt to cycle through the characters
●The Confirmation screen appears.
●If you make a mistake, press w until the incorrect character begins blinking. Then enter the correct character by pressing rt.
C Close the Confirmation screen.
Press MENU.
NOTE:
The characters available for the station name (ID) are
Fine-Tuning Channels Already Stored
Perform steps 1 and 2 of “Manual Channel Set” on page 40 to access the Confirmation screen before continuing.
D Switch the stations.
Press OK.
●The Confirmation screen appears.
●Repeat steps 1 – 4 as necessary.
E Close the Confirmation screen.
Press MENU.
Set Stations (B)
Set station names other than the ones registered in your recorder.
Perform steps 1 and 2 of “Manual Channel Set” on page 40 to access the Confirmation screen and then perform step 1 and 2 of “Set Stations (A)” above before continuing.
A Select the character for station name.
Press e until the first letter of the station name begins blinking.
A Select the channel to fine-tune.
Press rt w e until the channel you want to tune begins blinking.
B Access the Manual Channel Set screen.
Press OK twice. The Manual Channel Set screen appears.
C Perform tuning.
Press e until
●The Confirmation screen appears.
●Repeat steps 1 – 3 as necessary.
D Close the Confirmation screen.
Press MENU.