JVC HR-S5800AM, LPT0598-001A, 0701MNV*ID*PJ Timer Recording, Auto SP→LP Timer Auto Timer

36EN

TIMERRECORDING(cont.)

Auto SP→LP Timer Auto Timer

If, when timer-recording in SP mode, there is not enough tape to record the entire programme, the recorder automatically switches to LP mode (with PAL broadcasts) or EP mode (with NTSC broadcasts) to allow complete recording.

For Example . . .

Recording a PAL-broadcast programme of 210 minutes in length onto a 180-minute tape.

Approximately 150 minutes	Approximately 60 minutes
SP mode	LP mode

Total 210 minutes

Make sure you set "AUTO SP→LP TIMER" to "ON" at the Function Set screen before the timer-recording starts.

	ACCESS MAIN MENU
1	SCREEN
	Press MENU.
	ACCESS FUNCTION SET
2	SCREEN
	Press PUSH JOG %Þ to place the pointer next to
	"FUNCTION SET", then press OK or PUSH JOG #.
3	SELECT MODE
	Press PUSH JOG %Þ to
	place the pointer next to	PREVIOUS PAGE
	"AUTO SP→LP TIMER",	PROG. NAVIGATION	ON
		AUTO SP=LP TIMER	ON
	then press OK or PUSH	VIDEO STABILIZER	OFF
	JOG #to select "ON".	S-VHS	ON
		S-VHS ET	OFF
		[5/°] =
		[MENU] : EXIT
	RETURN TO NORMAL
4	SCREEN
	Press MENU.

When the Auto Timer is set to ON the timer is automatically engaged when the recorder power is turned off and automati- cally disengaged when the recorder is powered back on.

	ACCESS MAIN MENU
1	SCREEN
	Press MENU.
	ACCESS FUNCTION SET
2	SCREEN
	Press PUSH JOG %Þ to	MAIN MENU
	place the pointer next to	PROGRAMME NAVIGATION
	"FUNCTION SET", then
		FUNCTION SET
	press OK or PUSH JOG #.	TUNER SET
		INITIAL SET
		[5/°] =
		[MENU] : EXIT
3	SELECT MODE
	Press PUSH JOG %Þ to	FUNCTION SET
	place the pointer next to
		B. E. S. T.		ON
	"AUTO TIMER", then press	PICTURE CONTROL		AUTO
		PAL/MESECAM		AUTO
	OK or PUSH JOG #to	NTSC	NTSC3. 58
	select either "ON" or "OFF".	AUTO TIMER		ON
		O.S.D.		ON
		NEXT PAGE
		[5/°] =
		[MENU] : EXIT
	RETURN TO NORMAL
4	SCREEN
	Press MENU.

NOTE:

For safety, when Auto timer is set to "OFF", all other recorder functions are disabled while the Timer mode is engaged. To disengage the timer, press ä.

NOTES:

●If you have programmed the recorder to timer-record 2 or

more programmes, the second programme and those thereafter may not fit on the tape if you set "AUTO SP→LP TIMER" to "ON". In this case, make sure the mode is not engaged, then set the tape speed manually during timer programming.

●In order to ensure that the recording fits on the tape, this feature may leave a slight non-recorded section at the end of the tape.

●There may be some noise and sound disturbance at the point on the tape where the recorder switches from SP to LP (or EP) mode.

●The Auto SP→LP Timer feature is not available during ITR (Instant Timer Recording), and the feature will not work properly with any tapes longer than E-180 or with some tapes of shorter lengths.