Beko 40WLU530HID PC Setting, Phase, Switching to the Hdmi mode, Hdcp Optional

Page 30

9.2.3-PC Setting

Enter into the SETUP menu from the Main Menu by pressing the MENU button in the PC mode. In order to make the necessary settings in this menu, you can use the right- left, up-downmovement buttons on your remote control. You can make the following settings for your monitor in this menu.

9.2.4-HORIZONTAL POSITION:

Horizontal position setting

9.2.5-VERTICAL POSITION: Vertical position setting

9.2.6-CLOCK

This is the pixel clock frequency. User can narrow down or enlarge the display by selecting a desired value.

9.2.7-PHASE

Using the right/left movement buttons, you can ensure that the colors and shapes are exactly consolidated on the PC image.

9.2.8-AUTOCONFIGURATION

The most suitable geometric settings in accordance with the input signal are configured by this function.

For this operation, select the AUTOCONFIGURATION tab and press OK button. You can adjust the volume level of the source you have connected to the Audio-In input at the back of your TV by using the VOL+/VOL- buttons.

Note 1: 4:3, 16:9 and 14:9 picture formats are supported in 16:9 panels. Only 4:3 picture format is supported in 4:3 panels.

Note 2: In the Monitor mode, you can make the Brightness, Contrast, Sharpness, Red, Green and Blue Settings from the PICTURE menu.

Switching to the HDMI mode

Connect to the HDMI input at the back of your TV by using the connector located on your PC or your digital video-transmission device with a suitable cable (not supplied with the TV).

Note 1: To be able to watch an image in the HDMI mode, your computer must be equipped with a HDMI graphic card.

You may display the resolution information by pressing the INFO button.

Note 2: Scart1 To connect a RGB- supported external device to your television, you must use a Scart cable supporting RGB. In this case, if your external device supports, you can set the output as RGB.

HDCP (Optional)

Your TV supports HDCP feature. To use this feature, you must set up a connection to your TV set’s HDMI video port and select HDMI by pressing the AV key on your remote control.

9.2.9-PICTURE FORMAT

You can select the PC image to be displayed in 16:9, 14:9 or 4:3 formats.

9.3-Connecting a video recorder device and a digital satellite receiver

Ant In

Scart 1 TV In/Out

Scart 2 AUX In

Ant Out

Digital Satellite Receiver

Ant In

Ant Out

SCART Socket

Video Recorder

28

Ant Insocket

SCART

Rear of the Television

Page 29 Page 31
Image 30
Page 29 Page 31
Contents Operating Instructions Table of Contents Superior features of your integrated digital television Cleaning the screen and cabinetDisposing of your TV at the end of service life Important InformationChanging the plug Brown LiveFeatures of your new television Special FeaturesImportant Safety Instructions Make Sure that allNever operate your Page Start Powering on your TV and the initial useInitial power on and performing settings Aerial connectionYour new television TV Control PanelRear and Side External Connections Remote Control Digital Mode OnlyPerforming the initial power-on settings TV controlsTurning on the TV and Setting the Channels Performing Digital TuningAutomatic Tuning of Channels and Storing in the Memory Manual tuning of channels and storing in the memory Program TableElectronic TV Guide EPG Creating favorite channels listAccess Control Digital FeaturesLanguage Settings TimersCommon Interface Module Performing Analogue TuningFavourite Lists System MenuIf you do not know the channel number Confirm your selection withDeleting a stored channel Skipping a stored channelTo name the channels Settings of Your New Television Sound Menu SettingsEqualizer Picture Menu SettingsDialog Clarity Picture MenuTint Color TemperatureDNR Noise reduction Optional Active Contrast OptionalFeatures Menu Settings Active Antenna Other picture featuresUsing PIP Feature Picture in Picture ZoomPIP Position Switching the locations of the Main screen and PIP screenPAT Mode PIP SizeTeletext Analogue Clock Temporary TV Picture UpdateQuestion Answer Button Reveal FastextExternal equipment connection Headphone ConnectionHigh Definition HD ready Connection types for external devices PC ModeSwitching to the PC mode PC ConnectionSwitching to the Hdmi mode PC SettingPhase Hdcp OptionalFailure Possible cause Solution Help and tipsTechnical specifications chart General technical specificationsMain UK Transmitter Stations Guarantee Television What is covered?HOW to Obtain Service FAZ.801-01
Top Page Image Contents