Installing and Removing Flat Panel Screen
Position top slots of mounting plate (B) onto phillips hex head screws on wall plate (A) as shown in figure 4.1. NOTE: Sides of mounting plate (B) must be outside of wall plate (A) on both sides as shown in figure 4.2.
4 Guide slots of mounting plate onto four phillips hex head screws as shown in figure 4.3.
Push or pull from top or bottom of screen to adjust tilt as shown in figure 4.4. The tilt can be adjusted to a maximum of 15° forward or 5° backward. To lock the screen into the desired tilt position, tighten phillips hex head screws on both sides of mount.
To remove screen from mount, loosen screws one full turn and lift screen off of mount.
WARNING
•Do not lift more weight than you can handle. Use additional man power or mechanical lifting equipment to safely handle placement of the screen.
CAUTION
•Do not tighten screws with excessive force. Overtightening can cause damage to mount. Tighten screws to 40 in. • lb (4.5 N.M.) maximum torque.
CAUTION
•Be careful not to pinch fingers when pushing screen from the bottom.
screen
SLOT | phillips Hex |
| |
| head screw |
B
A
B A
phillips Hex head screwS
fig. 4.3
fig. 4.1 | phillips Hex |
| head screwS |
SCREEN
TOP VIEW
fig. 4.2 | WALL |
|
Sides of mounting plate (B) on outside of wall plate (A)
fig. 4.4
8 of 34 | ISSUED: |
© 2009, Peerless Industries, Inc. All rights reserved. All other brand and product names are trademarks or registered trademarks of their respective owners.
Peerless Industries, Inc.
3215 W. North Ave. Melrose Park, IL 60160 www.peerlessmounts.com