Kathrein UFD 505 manual Connection and putting into operation, Second receiver on the command set

Connection and putting into operation

	The remote control features 2 command sets, making it possible to operate 2
	receivers independently of each other in one room (not together with a twin receiver).
Note	For this purpose, program one receiver on the command set 1 and the
	second receiver on the command set 2.
	￿￿Switch on receiver 1 and receiver 2 off with the power switch
	￿￿Press and hold the ￿button.
	￿￿Enter "901" with the number buttons.
	￿oTadopt the code, press the ￿button to switch receiver 1 to standby and
	then switch off the device at the power switch.
	￿￿Switch on receiver 2.
	￿￿Press and hold the ￿button.
	￿￿Enter "902" with the number buttons.
	￿oTadopt the code, press the ￿button to switch receiver 2 to standby and
	then back into operation. Now switch on receiver 1 again.
	￿￿Press and hold the ￿button.
Note	￿￿Enter "903" with the number buttons.
	When carrying out the first two settings, the remote control must be di-
	rected at the respective receiver (when switched on).
	By pressing the ￿button, you can now switch between the two command sets A
	and B (toggle function) and alternately operate both receivers.
	Command set 1 is always active as the on-delivery setting.
Note	If you are operating only one receiver and the active command set is switched over by
	mistake so that this receiver can no longer be operated, the remote control can be ea-
	sily switched back to command set 1. For this purpose, follow the procedure described
	above.

11