Operating instructions
The following section is specifically intended for the specialist dealer. You only need to read this section if you are carrying out the installation yourself.
You will find sample configurations in the section "Connection examples".
First carry out all installation work before connecting the receiver to the mains power supply.
Refer to the information provided in the section "Safety instructions“.
To connect receiver
Sat-IF connection
Connect the
Use a coaxial cable with a standard F connector for this purpose.
If you need to fit the
strip the cable insulation as shown in the diagram (you will need to fold back the braid) and
slide the
When fitting the connector make sure that no wires of the shield braid make con- tact with the inner conductor. This could otherwise cause a
The quality of the reception signal depends on a good connection!
Preconditions for receiving digital signals
Make sure that your satellite antenna system is equipped with at least one univer- sal LNB to facilitate digital reception in the high band range.
Presetting of receiving system
The control signals for conventional receiving systems (satellite dishes) are preset, i.e. 14/18 V for polarisation changeover and 22 kHz switching signal for LOW/HIGH band changeover on multifeed reception systems.
The presetting will need to be changed in the installation menu, menu point "DiS- EqC" if UFO or tone burst switching matrices are used in the receiving system.
Refer to the section "Installation menu, DiSEqC menu“ for this purpose.
It is important that you observe the application information provided for the matrix used.
14