Kathrein UFD 505 manual LNB-supply voltage, TV and video recorder connection, Audio connection

Page 15

Operating instructions

LNB-supply voltage

If the feed system (LNB) is powered by an external supply voltage and the LNB supply voltage is not used for switching over polarity (e.g. Kathrein feed system UAS 330), the LNB supply of the receiver must be set to "OFF" (see section "Installation menu, LNB configuration“).

TV and video recorder connection

Use a SCART cable to connect the satellite receiver (TV SCART) and TV set.

If your TV set is equipped for stereo output, you can receive the sound in stereo via the SCART connection.

Also use a SCART cable to connect the satellite receiver (VCR/AUX SCART) and the video recorder.

Audio connection

If you wish to reproduce the sound via a hi-fi system, connect a corresponding Cinch cable from the audio Cinch sockets on the receiver to the input sockets on your hifi system.

The digital output is designed to facilitate connection to a Dolby Digital System.

Inserting batteries in the remote control

Remove the cover on the battery compartment on the underside of the remote con- trol.

Insert the two supplied batteries in the remote control. Ensure correct polarity of the batteries, the + and – markings are indicated inside the battery com- partment.

Slide the cover back into the casing and lock in position.

Used batteries are special waste! Therefore do not throw batteries into the house- hold waste but rather deposit them at a collection depot for old batteries!

15

Image 15

Contents Order no Page Important Notes Safety InstructionsFirst time operation Oscillator frequency L.O Changing the oscillator frequency Remote frequency Important notes regarding operation Operating elements, displays and connections View of front panel View of rear panelFlap folded down Remote control handset keys Connection and putting into operation Second receiver on the command setMenu concept Button functionsAlphanumeric entries Language selection- OSD Operating instructionsSat-IF connection Preconditions for receiving digital signalsPresetting of receiving system To connect receiverAudio connection Inserting batteries in the remote controlLNB-supply voltage TV and video recorder connectionFirst steps Factory setting of receiverImportant on-screen displays Programme selectionSelecting a TV programme Radio programme listReception status Reception status radio Switching over to radio programmeOn-screen displays On Screen Display Selecting a TV programme by number entrySelecting a radio programme by number entry VPS signal Timer-settingsEPG timer programming Programme overviewFull EPG Mute Sound settingsSetting the volume Stereo and two-channel sound reproductionProgramme lists Selecting programmes last receivedFavourite programmes To delete a programme To sort the channelsTo add a programme manually Incorrect parameter To remove satellite Setting up a satelliteSatellites add/remove To enter a nameParental lock PasswordFactory setting Entering a passwordSame accounts for transponder exchange Operation from the front panel Backup operationSystem parameters Setting system parametersScreen Summer timeTV type Picture formatOSD trans OSD colourInstallation menu LNB configuration10,7…11,7 GHz Low-band Low-band / analogue transmis Sion Changing the oscillator frequency Satellite search Antenna settingsTransponder selection TP set-up/searchDiSEqC UFO Set-up ErrorKHz signal High/Low Pos. A/B Tone Burst Tone burst Opt. A/B Factory setting Playback Recording„Display info Preparation Transferring programme listsTransferring operating software Technical features Technical annex Technical dataScart socket assignments AccessoriesConnection arrangement Connection examplesVHF/UHF VCR LNB Programme package Short technical lexiconDiSEqC components Eb/No ratioViterbirate Symbol rateTransponder Video bit rateService SatelliteDiSEqC menu 998.6246/1001/ZWT/ Subject to technical changes