Kathrein UFD 345 Receiver operation, Switching the unit on, Switching between TV and radio mode

Page 10

Receiver operation

In this chapter you learn how to select TV and radio programmes using your re- ceiver, and how to adjust the volume and set up other functions.

Switching the unit on

Once the supply voltage is connected the unit goes into standby mode.

The key on the remote control is used to switch between standby and normal operation. Operation is shown by means of a red LED indicator in the infrared sensor.

The last programme slot selected is tuned in (last-status memory).

Switching between TV and radio mode

 

Your receiver allows you to receive TV programmes or radio programmes.

 

After switching on, the receiver is in either the TV mode or the radio mode (de-

 

pending on the mode when switched off).).

 

In TV mode, the programme slot indicator in the on-screen display (OSD) begins

 

with "P". In radio mode, the screen is blanked out and the on-screen display begins

 

with "R..“.

 

 

Press the

key on the remote control handset to switch between TV- and

 

radio mode.

 

Note

In the initial setup menu, a continuous on-screen display of the radio programme

 

slot can be selected independent of the TV setting (see section: “Initial settings, On

 

Screen Displays “).

 

Selecting a programme

Use the numeric keys ... to select the desired programme directly. Example for a three-digit entry (with setting “free programme selection”): Selection of programme slot 147

1 is entered, programme slot 1 appears

4 is entered, programme slot 14 appears

7 is entered, programme slot 147 now appears.

or

Use the keys to step through the programmes in succession.

After the programme changeover, the programme slot and programme name are superimposed on the screen for approximately three seconds.

10

Image 10
Contents Kathrein Satellite Receiver UFD Contents Controls, displays and connections Front panel Remote control handset keysRear panel connections Safety instructions Important notes regarding operationImportant notes for siting and installation Connecting up the unit Connecting up and putting into operationInstalling the receiver Power supplySatellite signal connection Receiving system presetsTV and video recorder connection VCR Inserting batteries into remote control handsetDecoder connection Receiver operation Switching the unit onSwitching between TV and radio mode Selecting a programmeAdjusting volume, balance and tone Muting the soundVideo recorder playback VCR Operating the receiver without remote controlStereo- / Mono- / Channel changeover SAT/TV changeoverDisplaying the Info menu and programme overview Displaying InfoPicture optimisation when reception is weak Programme overviewProgramming TV programmes Tuning in TV programmesVideo menu Polarisation Satellite frequencyPolarisation/Orbit position Orbit positionDecoder menu Programme nameAudio frequency Audio modeAudio menu Audio de-emphasis for sound type Mono wide onlyTuning in radio programmes Initial settingsRadio menu Calling the initial setup menu LNB supply voltage in standby OSD languageLNB supply voltage Programme selectionOscillator frequency Changing the oscillator frequencySettings in the DiSEqC DiSEqC menuTone burst KHz signalTone-burst and DiSEqC-signal DiSEqCDiSEqC Repeat Switching over remote control’s command setRemote Features Specifications Scart socket assignments Temperature rangeAccessories GeneralVideo- and Audio Setup Menu Menu structureRadio Setup Menu Possible settingInitial Setup Menu Connection example / Service note Service notePage 9985.729/0,5/06.98/SKS/PF Subject to alterations