Kathrein UFD 345 manual Initial Setup Menu

Page 31

Menu structure

Initial Setup Menu

Return (stepwise) into normal programme mode with key .

Save settings with key S (press twice).

Select menu entries with .

Make the setting with or with the numeric keys for frequency setting .

Call initial setup menu Disconnect the power supply,

Press both CH buttons on infrared and keep pressed,

Reconnect the power supply!

OSD lang.

LNB supply

LNB supply in standby

Prog. Selectn.

On-screen display

OSD

Oscillator menu...

DiSEqC-

menu....

Possible setting:

Ger, Eng, Fre ,

On, Off

On, Off

1-, 2-, 3-digit or free input

Off, On

LO 1

LO 2

LO 3

LO 4

22 kHz

Tone Burst

DiSEqC

DiSEqC Rept

Remote freq.

Frequency range

9000 ... 12000

9000 ... 12000

9000 ... 12000

9000 ... 12000

Off, High/Low or Pos A/B

Off, Pos.A/B or Opt. A/B

Off, On, Remote

Off, On

920 .. 2150

31

Image 31
Contents Kathrein Satellite Receiver UFD Contents Controls, displays and connections Front panel Remote control handset keysRear panel connections Important notes regarding operation Safety instructionsImportant notes for siting and installation Power supply Connecting up and putting into operationInstalling the receiver Connecting up the unitReceiving system presets Satellite signal connectionTV and video recorder connection VCR Inserting batteries into remote control handsetDecoder connection Selecting a programme Switching the unit onSwitching between TV and radio mode Receiver operationMuting the sound Adjusting volume, balance and toneSAT/TV changeover Operating the receiver without remote controlStereo- / Mono- / Channel changeover Video recorder playback VCRDisplaying Info Displaying the Info menu and programme overviewProgramme overview Picture optimisation when reception is weakProgramming TV programmes Tuning in TV programmesVideo menu Orbit position Satellite frequencyPolarisation/Orbit position PolarisationProgramme name Decoder menuAudio de-emphasis for sound type Mono wide only Audio modeAudio menu Audio frequencyTuning in radio programmes Initial settingsRadio menu Calling the initial setup menu Programme selection OSD languageLNB supply voltage LNB supply voltage in standbyChanging the oscillator frequency Oscillator frequencyDiSEqC menu Settings in the DiSEqCDiSEqC KHz signalTone-burst and DiSEqC-signal Tone burstDiSEqC Repeat Switching over remote control’s command setRemote Features Specifications General Temperature rangeAccessories Scart socket assignmentsMenu structure Video- and Audio Setup MenuPossible setting Radio Setup MenuInitial Setup Menu Service note Connection example / Service notePage 9985.729/0,5/06.98/SKS/PF Subject to alterations