Satellite signal connection

Connecting up and putting into operation

	Connect inner hollow conductor plug to the power supply socket (6).
Caution!	If the power supply cable is modified or a different one is used, it is essential to
	check for correct polarity. Incorrect polarity will result in damage to the receiver.
	For fixed applications use the accompanying
	power supply unit 230 V~/16 V=.

∙Connect the Sat IF input of the receiver to the satellite receiving system.

∙For the connection use a coaxial cable with an F-type connecting plug. If the F connector is not yet fitted to the cable:

∙Insulate the cable as indicated in the following illustration, and

∙Carefully screw the F connector onto the cable end until it is firmly seated on the cable.

Attention!Do not use any tools to screw the F plug onto the cable or to tighten to the F socket. Put the connectors on hand-tight only.

Attention!When fitting the plug, make certain that none of the fine wires of the braided shield makes contact with the inner conductor giving rise to a short-circuit.

Receiving system presets

Presetting carried out for the control signals was for conventional receiving sys- tems, thus 14/18 V for polarity switching and 22 kHz switching signal for satellite selection in the case of multifeed receiving systems.

If DiSEqC or tone-burst switching matrices are to be used in the receiving system, the setting must be selected for "DiSEqC" signal or "Tone Burst” in the initial setup menu at submenu “DiSEqC“.

For this, refer to section: “Initial settings, DiSEqC menu“.

Also take note of the technical guide for the matrices.