Kathrein UFD 345 manual Inserting batteries into remote control handset, Decoder connection

Connecting up and putting into operation

TV and video recorder connection (VCR)

∙Connect-up the satellite receiver (TV Scart socket) and TV set with a Scart ca- ble.

If your TV set has stereo capability, a Scart connection allows you to receive the sound in stereo.

∙Connect-up the video recorder and satellite receiver (VCR Scart socket) again using a Scart cable.

Decoder connection

	You can also connect-up a decoder to the receiver for Pay-TV programmes.
	No further setting is necessary for decoders that require a video signal and supply
	a switching signal, such as Premiere decoder and Videocrypt decoder, for exam-
	ple..
Important	With decoders that do not supply a switching voltage, the receiver must be pro-
	grammed appropriately beforehand (see “The video menu” section in chapter “Pro-
	gramming TV programmes“).
	Also take note of the decoder specification!
	∙ Using a Scart cable connect-up the decoder to the decoder Scart socket.

Inserting batteries into remote control handset

∙Remove the cover on the rear of the remote control handset.

∙Insert both of the batteries supplied into the remote control handset. Make certain that the batteries are inserted with the correct polarity!

∙Replace the cover again.

Note	Exhausted batteries are special waste and should not be disposed of with house-
	hold refuse. Instead, hand them in to a collection centre for used batteries!

9