Kathrein UFD 345 manual Safety instructions, Important notes regarding operation

Page 5

Safety instructions

The following section contains important information relating to operation, place of installation and connecting-up of the receiver. Read these notes carefully before putting the unit into operation.

Important notes regarding operation

Extended absence/Thunderstorms

During periods of extended absence or at the onset of thunderstorms always dis- connect the unit from the supply, or withdraw the mains plug if the power supply unit is used. This also applies to any other equipment attached.

Mains lead

Make certain that the mains lead (power supply lead) is undamaged. Never put the unit into operation if the mains lead is damaged.

Cleaning

Withdraw the PSU mains plug before cleaning the unit. Use a dry cloth for clean- ing.

Children-at-play

Pay attention that children do not insert objects into the ventilation slots. There is a risk of mortal danger due to electric shock.

Repairs

On no account remove the housing cover since there are dangerous voltages in- side the unit that may be contacted. The unit must only be opened by qualified specialists, so allow them to carry out any repairs or adjustments to your receiver. Unauthorised opening entails loss of guarantee.

The electrical safety of the unit can be affected by improper tampering with it

The manufacturer‘s liability excludes accidents occurring to the user when the unit is opened.

5

Image 5
Contents Kathrein Satellite Receiver UFD Contents Controls, displays and connections Rear panel connections Remote control handset keysFront panel Important notes regarding operation Safety instructionsImportant notes for siting and installation Installing the receiver Connecting up and putting into operationConnecting up the unit Power supplyReceiving system presets Satellite signal connectionDecoder connection Inserting batteries into remote control handsetTV and video recorder connection VCR Switching between TV and radio mode Switching the unit onReceiver operation Selecting a programmeMuting the sound Adjusting volume, balance and toneStereo- / Mono- / Channel changeover Operating the receiver without remote controlVideo recorder playback VCR SAT/TV changeoverDisplaying Info Displaying the Info menu and programme overviewProgramme overview Picture optimisation when reception is weakVideo menu Tuning in TV programmesProgramming TV programmes Polarisation/Orbit position Satellite frequencyPolarisation Orbit positionProgramme name Decoder menuAudio menu Audio modeAudio frequency Audio de-emphasis for sound type Mono wide onlyRadio menu Initial settingsTuning in radio programmes Calling the initial setup menu LNB supply voltage OSD languageLNB supply voltage in standby Programme selectionChanging the oscillator frequency Oscillator frequencyDiSEqC menu Settings in the DiSEqCTone-burst and DiSEqC-signal KHz signalTone burst DiSEqCRemote Switching over remote control’s command setDiSEqC Repeat Features Specifications Accessories Temperature rangeScart socket assignments GeneralMenu structure Video- and Audio Setup MenuPossible setting Radio Setup MenuInitial Setup Menu Service note Connection example / Service notePage 9985.729/0,5/06.98/SKS/PF Subject to alterations