Installation Instructions | iCMPFM1S/iCMPFM1B |
1
1 X4
C
7/32" (5.5mm)
2 X4
3 | (Y, Z) X4 | C |
1/2" (12.7mm)
4 X2
INSTALL WALL PLATE TO WALL
WARNING: Failure to provide adequate structural strength for this component can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the structure to which this component is attached can support five times the combined weight of all equipment. Reinforce the structure as required before installing the component.
1.Level wall plate (C) and mark locations of pilot holes.
2.Drill 7/32" (5.5mm) diameter pilot holes into wood studs.
3.Using 1/2" (12.7mm) wrench, install screws (Y) through flat washers (Z), wall plate (C), into wood studs.
4.Open both display latches.
11