NetComm NP3640 manual TCP/IP Tab

Page 30

TCP/IP Tab

Selecting this tab will allow configuration for the TCP/IP network protocol. The basic options are:

Dynamic IP Address (DHCP) - The IP address is obtained automatically, from a DHCP Server on your network.

Fixed IP Address - You must enter the IP address, Subnet Mask, and Gateway Address.

IP Address - Select an unused IP address from the address range used on your LAN.

Subnet Mask - Use the same values as computers on your LAN (or on the same LAN segment, if you have a Router).

Gateway - Use the same values as computers on your LAN (or on the same LAN segment, if you have a Router).

Some Print Server models also support the Auto-IP function. If the Print Server is set to Dynamic IP Address, but there's no DHCP server found on the network, the Print Server will get an IP from the range of 169.254.1.1 ~ 169.254.254.254 automatically. In this case, even though the Print Server was initialized with an Auto-IP, it will change to DHCP whenever a DHCP server is detected.

The TCP session parameters should only be changed if advised to do so by your Network Administrator or Print Server Technical Support.

www.netcomm.com.au

Rev. 1 - YML657

Page 30

NP3640 Fast Ethernet Mini Print Server User Guide

Image 30
Contents Page Contents Introduction Connecting your Mini Print Server Green LED Red LED Description Diagnostic Push ButtonLED Indicators Yellow LED Orange LED DescriptionAdvanced Configuration and Management Configuring your Mini Print ServerConfiguration Methods Web Based Configuration and ManagementUsing the Windows Wizard ProcedureRev YML657 Rev YML657 NP3640 Fast Ethernet Mini Print Server User Guide Configuring your Computers Printing MethodsWhich printing method should I use? Checking your Network Protocols Windows Windows 2000/XP Setup Windows Peer-to-peer PrintingRev YML657 NP3640 Fast Ethernet Mini Print Server User Guide Windows 9x/ME Setup Rev YML657 NP3640 Fast Ethernet Mini Print Server User Guide Management Advanced Port Options Windows SMB Printing Capture Settings Printing from MS-DOS ProgramsWindows with Server-based Print Queues Windows LPR Printing Choose Standard TCP/IP Port, then click New PortMacintosh AppleTalk AppleTalk SetupAdvanced Setup and Management PrintingLPR printing Setup Macintosh OSBiAdmin Management Utility InstallationRequirements Rev YML657 NP3640 Fast Ethernet Mini Print Server User Guide Icons Device StatusPrinter Status Configuration UpgradeWizard Menus Configuration System TabTCP/IP Tab AppleTalk Tab NetBEUI Tab Internet Printing Tab Port Tab Physical PortLogical Port NetWare Snmp Tab Web-Based Management PreparationConnecting to the Print Server Configuration ScreensServer Status Configure Server AppleTalk NetBEUI TCP/IP ConnectionRemote Printer Mode Print Server ModeGeneral Rev YML657 Snmp Simple Network Management Protocol Management StationsTrap Receivers Logical Printers Internet Printing Special Features IPP Server ConfigurationInternet Printing Protocol IPP Installing from the CD-ROM IPP Client Setup Windows 95/98/Me/NT 4.0/XPIPP Client Configuration Windows 95/98/ME/2000/XP/NT Installing using IPPCLIENT.EXEChanging the IPP Port Settings IPP Client Setup Windows 2000/XP Using IPP Printers Mail Server Internet Mail PrintingSystem Requirements Internet Print ServerInternet Mail Printing Configuration User SoftwareInstallation User Software Using the new Port Checking the Printer DriverPrinting through the Internet Management Station Settings Configuring the Print Server for SnmpSnmp Settings Trap Receiving Station SettingsTroubleshooting FaxHardware & LAN Problems AppleTalk Macintosh Problem, perform the following steps Novell NetWare Windows Printing Problems Click OK to see the Print Port Configuration screen, as Rev YML657 NP3640 Fast Ethernet Mini Print Server User Guide Preparing for TCP/IP Printing Network Server ConfigurationWindows NT Server Adding a TCP/IP Remote PrinterEnter the appropriate logical printer number. e.g. L1 Novell NetWare Configuration Methods Bindery or NDSSetup Wizard Windows 2000 ServerOther Method BiAdminConfiguration Data GeneralSetup for Ndps NetWare OverviewCreating an Ndps Manager Object Creating an Ndps Printer Agent Load NdpsmTrademarks and Notices Registering your NetComm ProductUnix Systems Warranty Registration Form Page Product Warranty Limitations of Warranty