Connecting a camcorder

Chapter 2: Connecting your TV

Connecting a VCR and antenna or Cable TV (no Cable box)

You will need:

one signal splitter

three coaxial cables

two sets of standard A/V cables

¥For better picture performance, if your VCR has S-video, use an S-video cable (plus the audio cables) instead of the standard video cable. However, do not connect both types of video cables to VIDEO 1 at the same time or the picture performance will be unacceptable.

¥If you have a mono VCR, connect L/MONO on the TV (VIDEO 1) to your VCRÕs audio out terminal using the white audio cable only.

To view the antenna or Cable signal:

Select the ANT 1 video input source on the TV.*

To view the VCR:

Turn ON the VCR. Select the VIDEO 1 video input source on the TV.*

To use the TV Guide On Screen¨ recording features:

1.Connect the G-LINK®cable according to the instructions on page 21.

2.Make sure the VCR is connected to the A/V OUT terminals on the TV (see illustration).

3.Set the VCR to the appropriate line input (refer to your VCR owner’s manual for details), and then turn OFF the VCR.

4.See Chapter 5 for details on setting up the TV Guide On Screen® system.

5.See Chapter 7 for details on using the TV Guide On Screen® system.

From Cable TV or antenna

Signal splitter	IN
OUT	OUT

Stereo VCR

VIDEO	AUDIO
L	R	IN from ANT
CH 3		IN
CH 4
		OUT to TV
		OUT
L	R

TV lower back panel									TV upper back panel

Note: The VIDEO/AUDIO OUT terminals output signals from the ANT 1, ANT 2, VIDEO 1, and VIDEO 2 terminals when the appropriate input mode is selected.

The unauthorized recording, use, distribution, or revision of television programs, videotapes, DVDs, and other materials is prohibited under the Copyright Laws of the United States and other countries, and may subject you to civil and criminal liability.

You will need:

one set of standard A/V cables

¥If you have a camcorder with S-video, you can use an S-video cable instead of a standard video cable for better picture performance. Plug the S-video and standard audio cables into the ÒVIDEO 1 INÓ inputs on the upper back panel of the TV instead of the inputs on the side panel.

To view the camcorder video:

Select the VIDEO 2 video input source (or the VIDEO 1 video input source when you use an S-video cable) on the TV.*

______________

*To select the video input source, press INPUT on the remote control (see page 56). To program the TV remote control to operate other devices, see Chapter 3.

Camcorder

S-VIDEO VIDEO AUDIO

OUT

VIDEO 2 inputs on TV side panel

#01E_012-022_27HL95

05.9.12, 15:32

Black

Toshiba 27HL95 Connecting a VCR and antenna or Cable TV no Cable box, Connecting a camcorder

Connecting a VCR and antenna or Cable TV (no Cable box)

You will need:

To use the TV Guide On Screen¨ recording features:

TV lower back panel