Programming channels into the TV’s channel memory

Chapter 6: Setting up your TV

Programming channels into the TV’s channel memory

When you press CHANNEL y or z on the remote control or

4. Open the Terrestrial menu, highlight Channel Program,

TV top panel, your TV will stop only on the channels stored in

and press ENTER.

the TV’s channel memory.

5. Highlight ANT 1 or

Follow the steps below to program channels into the TV’s

ANT 2, depending on

channel memory.

which antenna input

Terrestrial

you want to program

Input Configuration

ANT1

Channel Program

ANT2

Programming channels automatically

channels for, and then

Channel Add/Delete

Signal Meter

press ENTER to start

Your TV can automatically detect all active channels in your area

automatic channel

and store them in its memory. After the channels are

programming.

Navigate

Select RTN

Back EXIT Exit

programmed automatically, you can manually add or erase

individual channels.

ANT 1

Antenna

Note:

Scanning channels, please wait ...

52%

You must configure the antenna input sources before

Abort

programming channels (see page 35).

The TV will automatically cycle through all the channels

If the input signal type is set to Cable for an antenna input, the

for the antenna input you selected, and store all active

automatic channel programming process erases channels that

channels in the channel memory. While the TV is cycling

were previously programmed into the TVÕs memory.

through the channels, the message “Scanning channels,

If the input signal type is set to Antenna, the automatic channel

please wait” appears (as shown above).

programming process does NOT erase channels that were

6. To cancel channel programming, either press EXIT or

previously programmed into the TVÕs memory, but adds newly

found channels to the existing set of programmed channels. To

highlight Abort in the on-screen display and press ENTER.

remove a channel from the memory, you must manually delete it

When channel programming is done, press CHANNEL

(see next page).

y or z to view the programmed channels.

¥To tune the TV to a channel not programmed in the channel memory, you must use the Channel Number buttons on the remote control.

¥ Programming channels for an antenna input configured for
Cable will take substantially longer than for an antenna input
configured for Antenna. This is normal; however, once channel
programming is completed, you should not have to repeat the
programming process again unless your Cable TV service lineup	Channel
changes significantly.	Numbers

¥ If you have a CableCARDª inserted (page 12), channel programming for ANT 1 is disabled because the CableCARDª automatically loads the Cable channel list into the TVÕs channel memory.

To program channels automatically:

1. Make sure you have configured the antenna input sources. See page 35 for details.

2. Press MENU and open the Setup menu.

3. Highlight Installation and press ENTER. (A new set of		CHANNEL yz
Installation menu icons will appear on-screen.)		CHANNEL yz
Setup		TV top panel
Setup
Installation
Sleep Timer
On/Off Timer
PC Settings
PC Audio	No
HDMI Audio	Auto	CHANNEL z / y
Gray Level	2	CHANNEL z / y
Navigate	Select RTN Back EXIT Exit	MENU
Navigate	Select RTN Back EXIT Exit	(ENTER)
		(ENTER)
36	Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
36
#01E_035-037_27HL95	36	05.9.12, 15:36
Black
(E) 27HL95 *Web 213 : 276