Basic Operations
POWER
To turn the unit ON and OFF:
1.Plug the power cord into an active AC power outlet.
2.Press the POWER ON button to turn on the unit.
The display’s POWER/STANDBY indicator will light up (green) when the unit is on.
3.Press the POWER OFF button (on the remote controller or the unit) to turn off the unit.
The display’s POWER/STANDBY indicator turns red and the standby mode is set (only when turning off the unit with the remote controller).
VOLUME
To adjust the volume:
1.Press and hold the VOLUME
button (on the remote controller or the unit) to increase to the desired level.
2.Press and hold the VOLUME
button (on the remote controller or the unit) to decrease to the desired level.
MUTE
To cancel the sound:
Press the MUTE button on the remote controller to cancel the sound; press again to restore.
DISPLAY
To check the settings:
1.The screen changes each time the DISPLAY button is pressed.
2.If the button is not pressed for approximately three seconds, the menu turns off.
DIGITAL ZOOM
Digital zoom specifies the picture position and enlarges the picture.
1.Press the POINTER button to display the pointer. (
)
To change the size of the picture:
Press the ZOOM+ button and enlarge the picture.
The pointer will change to resemble a magnifying
glass. (
)
A press of the ZOOM- button will reduce the picture and return it to its original size.
To change the picture position:
Select the position with the ▲▼ buttons.
2.Press the POINTER button to delete the pointer.
AUTO ADJUST
To adjust the size or quality of the picture automatically:
Press the AUTO ADJUST button.
Information
AUTO ADJUST ON setting
When RGB (still picture) input
is selected ...... Fine Picture, Picture ADJ, Position,
and Contrast will be adjusted automatically.
When RGB (motion picture),
VIDEO, or Y/Pb/Pr (component) input
is selected ...... The screen size switches to ZOOM
mode automatically with the superimposed caption displayed fully only when the picture contains gray bars above and below the picture.
16