Setting RGB3 ADJ.
When the picture input from the RGB3 input terminal is distorted, select the most appropriate setting from among “1,” “2,” and “3.”
Example: Setting “2”
Press the PROCEED button on the remote controller to
display MAIN MENU on the screen, then...
1.Use the ▲ and ▼ buttons to select “FUNCTION,” then press the PROCEED button.
The “FUNCTION” screen appears.
2.Use the ▲ and ▼ buttons to select “RGB3 ADJ.”
F U N C T I O N
OSD | : | ON | |
OSD ADJ. | : | 1 | |
POWER MGT | : | OFF | |
GRAY LEVEL | : | 3 | |
CINEMA MODE | : | ON | |
|
| : | 1 |
RGB3 ADJ. |
|
LONG LIFE |
|
RESET |
|
SEL. | ADJ. EXIT RETURN |
3.To select “2”...
Use the and buttons to select “2.”
The mode switches as follows each time the or
buton is pressed: → 1 ↔ 2 ↔ 3 ←
F U N C T I O N
OSD | : | ON | |
OSD ADJ. | : | 1 | |
POWER MGT | : | OFF | |
GRAY LEVEL | : | 3 | |
CINEMA MODE | : | ON | |
|
| : | 2 |
RGB3 ADJ. |
|
LONG LIFE |
|
RESET |
|
SEL. | ADJ. EXIT RETURN |
4.Once the setting is completed...
Press the EXIT button to return to the main menu.
To close the main menu, press the EXIT button once more.
Information
When you adjust the RGB3 ADJ.
The position of the menu display will change. In such a case, be sure to adjust the position.
Restoring the factory default settings
Select “RESET” under the function menu. Note that this also restores other settings to the factory defaults.
Reducing burn-in of the screen
The brightness of the screen, the position of the picture, positive/negative mode and screen wiper are adjusted to reduce
Example: Setting “PLE” to “LOCK”
Press the PROCEED button on the remote controller to display the MAIN MENU on the screen, then proceed as follows.
1.Use the ▲ and ▼ buttons to select “FUNCTION,” then press the PROCEED button.
The “FUNCTION” screen appears.
2.Use the ▲ and ▼ buttons to select “LONG LIFE,” then press the PROCEED button.
F U N C T I O N
OSD | : | ON | |||
OSD ADJ. | : | 1 |
|
| |
POWER MGT | : | OFF | |||
GRAY LEVEL | : | 3 |
|
| |
CINEMA MODE | : | ON | |||
RGB3 ADJ. | : | 1 |
|
| |
LONG LIFE |
|
|
|
| |
RESET |
|
|
|
| |
SEL. |
| OK |
|
| RETURN |
PROCEED |
| EXIT |
The “LONG LIFE” screen appears.
3. Use the ▲ and ▼ buttons to select “PLE.”
L O N G L I F E
PLE | : | AUTO |
ORBITER | : | OFF |
INVERSE | : | OFF |
SCREEN WIPER | : | OFF |
SEL. | ADJ. | EXIT | RETURN |
4.Use the and buttons to select “LOCK.”
The mode switches as follows each time the or button is pressed:
AUTO ↔ LOCK
L O N G L I F E
PLE | : | LOCK |
ORBITER | : | OFF |
INVERSE | : | OFF |
SCREEN WIPER | : | OFF |
SEL. | ADJ. | EXIT | RETURN |
36