Pioneer DVH-P5900MP operation manual Receiving traffic announcements, Switching the RDS display

Section

03 Operating this unit

Limiting stations to regional programming

When AF is used, the regional function limits the selection of stations broadcasting regional programs.

1Press FUNCTION to select REG.

2Press aor bto turn the regional func- tion on or off.

Notes

!Regional programming and regional networks are organized differently depending on the country (i.e., they may change according to the hour, state or broadcast area).

!The preset number may disappear from the display if the tuner tunes in a regional station which differs from the originally set station.

!The regional function can be turned on or off independently for each FM band.

Receiving traffic announcements

TA (traffic announcement standby) lets you re- ceive traffic announcements automatically, no matter what source you are listening to. TA can be activated for both a TP station (a sta- tion that broadcasts traffic information) or an enhanced other network’s TP station (a station carrying information which cross-references TP stations).

1Tune in a TP or enhanced other net- work’s TP station.

TP indicator will light.

2Press TA to turn traffic announcement

standby on.

# To turn traffic announcements standby off, press TA again.

3Use VOLUME to adjust the TA volume when a traffic announcement begins.

The newly set volume is stored in memory and recalled for subsequent traffic announce- ments.

4Press TA while a traffic announcement is being received to cancel the announce- ment.

The tuner returns to the original source but re- mains in the standby mode until TA is pressed

again.

# You can also cancel the announcement by pressing SOURCE, BAND, a, b, cor dwhile a traffic announcement is being received.

Notes

!You can also turn the TA function on or off in the menu that appears with the pressing of

FUNCTION.

!The system switches back to the original source following traffic announcement recep- tion.

!Only TP and enhanced other network’s TP sta- tions are tuned in during seek tuning or BSM when TA is on.

Switching the RDS display

%Press DISPLAY repeatedly to switch be- tween the following settings:

Program service name—PTY information— Frequency

PTY (program type ID code) information is

listed on the next page.

# PTY information and the frequency appear on

the display for eight seconds.

# If a PTY code of zero is received from a station or the signal is too weak for this unit to pick up the PTY code, you cannot switch to PTY informa- tion display.

18 En