Operating the DSP details menu

Available accessories

1DSP display

Shows the DSP status.

2PL II indicator

Shows when the Dolby Pro Logic II is turned on.

%Press AUDIO and hold until AT EQ ap- pears in the display, then press AUDIO to display the DSP function names.

After AT EQ is displayed, press AUDIO repeat- edly, the following DSP functions appear in the display:

AT EQ (auto-equalizer on/off)—FRONT (speak- er setting)—HPF (cross-over frequency)— FRT-L (speaker output level)—TEST TONE (test tone)—TA (time alignment mode)—FL (time alignment adjustment)—PEQ-2 (3-band para-

metric equalizer)

# You can also use A.MENU button on the re-

mote control to select an audio menu.

# When you select TA OFF in TA INTIAL, you

cannot select FL.

# You cannot select AT EQ if auto TA and EQ

has not been carried out.

# To return to the display of each source, press BAND.

Using the auto-equalizer

The auto-equalizer is the equalizer curve cre- ated by auto TA and EQ (refer to Auto TA and EQ (auto-time alignment and auto-equalizing) on this page).

You can turn the auto-equalizer on or off.

Section

1 Press AUDIO and hold until AT EQ ap- pears in the display.

# If auto TA and EQ have not been carried out, SET A.EQ is displayed when AT EQ is selected.

	2 Press ato turn the auto-equalizer on.	Available
	2 Press ato turn the auto-equalizer on.
	AT EQ ON appears in the display.
	# To turn auto-equalizer off, press b.	accessories
	Auto TA and EQ (auto-time	accessories
	Auto TA and EQ (auto-time
	alignment and auto-equalizing)
	The auto-time alignment is automatically ad-
	justed for the distance between each speaker
	and the listening position.
	The auto-equalizer automatically measures
	the car interior acoustic characteristics, and
	then creates the auto-equalizer curve based
	on that information.
	WARNING
	To prevent accidents, never carry out auto TA and
	EQ while driving. When this function measures
	the car interior acoustic characteristics to create
	an auto-equalizer curve, a loud measurement
	tone (noise) may be outputted from the speakers.

CAUTION

!Carrying out auto TA and EQ under the follow- ing conditions may damage the speakers. Be sure to check the conditions thoroughly be- fore carrying out auto TA and EQ.

—When speakers are incorrectly connected. (e.g., When a rear speaker is connected to a subwoofer output.)

—When a speaker is connected to a power amp delivering output higher than the speaker’s maximum input power capabil- ity.

En 73